CrimeStopper SERIES II CS-2004DC II Installation And Operating Instructions Manual page 7

BROWN/BLACK WIRE: (-) AUX. OUTPUT #1 OR M.A.P.-Mobile Accessories Protection (Optional)
This is a programmable output wire that can operate two different ways:
1. (DEFAULT Operation) A Remote Auxiliary Output that provides a ½ Second (-) Negative pulse when Button
#3 is pressed and released to open a power trunk or hatch release. Connect to the Brown/Black wire if you
choose to use the on-board relay, or this wire can be connected to an external relay [if the on-board auxiliary
relay is being used for another function]. If using on-board relay, see pages 4 & 5, or for external relay see
following information: Connect Brown/black to terminal 85 of a relay to operate AUX device or function.
Connect terminal 86 or the relay to +12 Volts constant. Connect terminal 87 to +12Volts or Ground depending
on the type of circuit needed. Use Terminal 30 to activate the AUX function or device.
2. (MAP Operation) Provides a continuous (-) Negative output when the alarm system is put into VALET PARK
MODE. This can be used to interrupt the accessory wire of the vehicle, preventing unauthorized use of the
vehicle's audio or entertainment systems when VALET PARK MODE is ON, hence the name "MAP – Mobile
Accessory Protection".
Relay not included
OFF
ACC
IGN
START
WHITE/RED WIRE: (-) REMOTE OUTPUT #2 (Optional)
This wire provides a momentary (-) Negative auxiliary Output when Button #4 is pressed and held for at least 2
seconds. Connect to the Gray wire if you choose to use the on-board relay, or this wire can be connected to an
external relay [if the on-board auxiliary relay is being used for another function]. If using on-board relay, see pages
4 & 5, or for external relay see following information: Connect this wire to terminal 85 of a relay to operate an AUX
device or function. Connect terminal 86 or the relay to +12 Volts constant. Connect terminal 87 to 12Volts or
Ground depending on the type of circuit needed. Use terminal 30 to activate the AUX function or device. This
output is momentary and will stay active as long as the transmitter button is held down.
86 85
87
87A 30
KEY
CUT
SIDE
WIRING
MOBILE ACCESSORY PROTECTION
Brown/Black
Connect relay as shown to interrupt the power
wire of mobile accessories such as Audio system
or Video monitors. The Alarm will disconnect
these accessories when in VALET PARK MODE.
7
FM
105.5
RADIO, etc.