CrimeStopper SERIES II CS-2004DC II Installation And Operating Instructions Manual page 5

GRAY WIRE: (-) NEG. INPUT [COIL] FOR ON-BOARD 15A RELAY (Term #85, Step #1)
This input controls the function of an on-board relay. Connect to any desired Auxiliary or Optional wire from the
Brown 3-pin output harness. Connect the Gray wire to the Orange/Black for Dome light illumination, Brown/Black
for Auxiliary 1 or Red/Black for Auxiliary 2 function. (See diagram, next page)
WHITE/RED WIRE: (+/-) INPUT SOURCE FOR ON-BOARD 15A RELAY (Term #87, Step #2)
Connect to a +12 Volt source or Chassis Ground depending on the polarity of the circuit you are going to auxiliary
circuit or function you are going to activate with the Black/White output wire. Connect to +12V for Positive Circuits
or Chassis Ground for Negative circuits. This wire must be the same polarity as the Black/White wire. (See
diagram, next page).
BLACK/WHITE WIRE: (+/-) OUTPUT FROM ON-BOARD 15A RELAY (Term #30, Step #3)
Connect this wire to your Auxiliary device or Function. The function of this output depends on the connection of the
Gray wire and the polarity of this output matches the White/Red wire. (See diagram below)
BROWN/WHITE: (-) HORN HONK OUTPUT (Optional, May require a relay)
Connect to the Negative Horn Trigger wire usually located at or near the steering column. If the vehicle horn circuit
requires +12V, then a relay is required. RELAY WIRING: Connect the Brown/White wire to terminal 85, connect
relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the relay to the +12V positive
device/circuit to be activated.
WIRING
Orange/Black (-) Neg. Domelight Illumination
Brown/Black
(-) Neg. Auxiliary Channel #1
Red/Black
(-) Neg. Auxiliary Channel #2
Auxiliary 15A On-Board
relay wiring
Gray (Term #85)
White/Red (Term #87)
Black/White (Term #30)
5
Choose One
INPUT
+12V or
SOURCE
15A Relay Output:
Aux. #1, Aux. #2 or
Dome light Illumination