CrimeStopper SERIES II CS-2004DC II Installation And Operating Instructions Manual page 13

Series ii
Table of Contents

Advertisement

You can program each option individually or multiple options in one session. You may start with the lowest option #
and continue on to higher options without repeating the steps #1 through 3.
To Engage Option Programming:
1. Turn Key to the ON position.
2. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times and the LED will
light solid.
3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru
16). Press so that you get a light flash after each button press. If the unit did not flash the lights, then it did not
register your press. See chart below for option list.
4. When you reach the desired programming level, Press button #1(Lock) or #2 (Unlock) to change the option.
Pressing button 1 will provide one light flash and pressing Button 2 will provide 2 light flashes.
5. Turn Ignition OFF and check for changed features. Change each option individually repeating steps #1-5.
Option #
1
Auto lock with Ignition
2
Passive Arming
3
Active Re-Arm
4
Passive Locks
5
Parking Lights on w/Disarm
6
Brown/Black wire Function
7
Type of Carjack protection:
Active or Passive Carjack
8
Disarm on Trunk pop
9
Open Door Warning
10
Door Lock Pulse Time
11
Double Unlock Pulse
12
Enable / Disable Carjack Features
13
Starter Disable Relay Config.
14
Ignition Arm / Disarm
15
Factory Horn Chirp / Pulses
16
Option reset
OPTION PROGRAMMING Soft.686/697
Option Description
Lock Button #1
Unlock Button #2
OFF
ON
ON
ON
OFF
M.A.P.
*Trunk Pop
(Valet Park)
Passive
OFF
5 Sec.
3 Sec.
*0.75 Sec.
2 Pulses
Enable
*Disabled
Normally Open
*Normally Closed
ON
Pulse with Trip
Arm/Disarm Chirps
Only
& Pulse w/ Trip
Reset options
13
*
=Factory Default Values
TX Button #3
*ON
*OFF
*OFF
*OFF
*ON
(Aux. #1)
*Active
*ON
*60 Sec.
*1 Pulse
*OFF
*Arm/Disarm/
Warn Chirps &
Pulse w/ Trip

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents