Crestron DTT-15V2 Operation Manual page 14

Crestron DTT-15V2
10 DualTouch™ Technology Touchpanel: DTT-15V2
CAUTION: To avoid damage to the DTT-15V2 or to your video card, never
connect or disconnect the video or power cable while the DTT-15V2 or the UPX-2
are powered up.
NOTE: The maximum continuous current from equipment under any external load
conditions shall not exceed a current limit that is suitable for the minimum wire
gauge used in interconnecting cables. The ratings on the connecting unit's supply
input should be considered to prevent overloading the wiring.
NOTE: The USB cable may be extended using up to four 16-foot active extensions.
Each extension cable must contain a hub (repeater) to regenerate the USB signal
(maximum of 64 feet). For longer extensions, Crestron has tested and approved
IOGEAR USB Extender model GUCE50, which allows up to 150 feet over CAT5.
NOTE: Using high quality cable, the VGA cable may be extended up to a
maximum of about 10 meters (32.8 ft.) for analog VGA at 1024 x 768. If you need a
longer run, add VGA extenders or VGA distribution amplifiers.
1. Connect the RGB/VGA cable, linking the UPX-2 RGB OUTPUT A
connector to the DTT-15V2 RGB VIDEO IN connector.
2. Connect the USB cable, linking the UPX-2 USB port to the DTT-15V2
USB port.
3. Connect the power supply line cord to an AC outlet and the power supply
adaptor.
4. Plug the power adaptor cord into the DTT-15V2 DC IN port.
5. Power up the DTT-15V2. The power indicator should light up orange.
6. Power up the UPX-2. When a video signal is applied to the DTT-15V2, the
power indicator will turn blue.
DualTouch™ Technology Touchpanel
Operations Guide – DOC. 6342