5.8 Upper and lower limit frequencies
:Upper limit frequency
:Lower limit frequency
・ Function
These parameters are used to set the upper and lower limit frequencies which are
the largest and smallest frequencies, respectively, that the inverter can output.
Output frequency [Hz]
0 100%
Frequency setting signal
★ The inverter does not output
any frequency exceeding the .
■Parameter setting
Title
Upper limit frequency
Lower limit frequency
5.9 Base frequency
:Base frequency #1
・ Function
This parameter is used to set the base frequency according to the rated frequency of the
motor or the specification of the load.
Note) This is an important parameter required for setting the constant torque control area.
Base- frequency voltage #1
Output voltage [V]
Title
Base frequency #1
Upper limit frequency
Function
∼
∼
0
Function
∼ [Hz]
E-16
Lower limit frequency
Output frequency [Hz]
0 100%
Frequency setting signal
★ The output frequency cannot
be set below the .
Adjustment range
Output frequency [Hz]
Adjustment range
Default setting
Default setting