Before Installing Optional Add-On Cassette Or Board Option; Case 1; Case 2; Case 3 - Toshiba TOSVERT VF-P7 Instruction Manual

9.7 Before installing optional add-on cassette or board option

When using optional add-on cassette(s) or a board option with a model 200V-37kW or more or
400V-45kW or more, prepare for installing according to explanation below.
In any case, check that all the power sources are OFF before opening the front cover.
Note) Do not open the front cover, unless 10 minutes has passed after the
Option name
Vector option unit
PG feed back board
S20 option unit
F10M option unit

9.7.1 Case 1

1. Please extract wire-C from the
connector on board-B.
2. Remove board-A(attached to the
control board) and wire-C from the
control board.
3. For using again in the future, keep
board-A and wire-C which were
removed.
4. Attach the option according to
the instruction manual of each option.
The image after option attachment becomes as follows.
(Left: In the case optional add-on cassette,
Mandatory
5. Switch on power supply and change the setup of the parameter  into .
Flexible connecting board
Connector
Control board
Note)
Board-A, board-B and wire-C aim at the function of the speed search #2
among the auto-restart modes described in 6.13.1.
At case 1 or case 2-A, speed search #1 is performed. So, board-A, board-B
and wire-C are not needed in these cases.
power sources turned off and charge lamp is not lit.
Other than models above
Model
VEC001Z
VEC002Z
VEC003Z
TLS001Z
TLF001Z
Warning
Board-B
Right: In the case board option)
Optional
add-on
Connector
cassette
Control board
Note) Fix the board option with installation
stay and support screw.
I-13
Reference section
9.7.1 Case 1

9.7.1 Case 2

9.7.1 Case 3

Wire-C
Control board
Terminal block
Board option
Board-A