Care And Maintenance Of Your Fingerprint Reader - Toshiba Tecra M5 User Manual

4 If other fingerprint data is still displayed on the list, hold
down the
are all selected, then click Remove.
5 Click OK to make the changes permanent.
6 Check that all Fingerprint data was deleted on the
Fingerprint Storage Inspector screen.

Care and maintenance of your fingerprint reader

Failure to follow these guidelines and/or procedures might
result in damage to the reader or cause reader failure, finger
recognition problems, or lower finger recognition success
rate.
❖
Do not scratch or poke the reader with your nails or any
hard or sharp objects.
❖
Do not press the reader with too much pressure.
❖
Do not touch the reader with a wet finger or any wet
objects. Keep reader surface dry and free of water vapor.
❖
Do not touch the reader with a soiled finger. Minute
foreign particles on a soiled or dirty finger may scratch
the reader.
❖
Do not paste stickers or write on the reader.
❖
Do not touch the reader with a finger or any object with
built-up static electricity.
Observe the following before you swipe your finger on the
reader, whether for fingerprint enrollment/registration or
recognition.
❖
Wash and dry your hands thoroughly.
❖
Remove static electricity from your fingers by touching
any metal surface. Static electricity is a common cause of
reader failures, especially during dry seasons such as
winter.
❖
Clean the reader with a lint-free cloth. Do not use
detergent to clean the reader.
Fingerprint Authentication Utility
key and select each fingerprint until they
Control
Toshiba Utilities
215