Install Side Plates; Install Handler Brackets And Shoulder Bolts To Outside Of Frame - Craftsman 486.24838 Operator's Manual

INSTALL SIDE PLATES
STEP 3: (BEE FIGURE 3)
* Fasten the R.H Side Plate (bend facing out) to the
front three holes in the tractor frame using three
3/8" x 1" carriage bolts (K), three 1/2" washers (V)
(see note) and three 3/8" flange nuts (BB) For the
rear hole, use a 5/16" x 1" cardage bolt (N), a 1/2"
washer (V) and a 5/16" nyiock nut (CC). Place the 1/2"
washers (V) between the tractor frame and the side
plate Repeat for L.H. side plate•
* Reinstall the browning shield onto the tractor frame
using the odginal screws
NOTE: If there is an engine mounting plate (shown with
dotted lines) leave the 1/2 washer off the bolt that goes
through the plate.
7
5/16" x 1" ENGINE MOUNTING |
|
CARRIAGE BOLT (N) PLATE
SEE NOTE
5/16"
NYLOCK
NUT (CC) ..... -
i
FIGURE 3
(3)
CARRIAGE
BOLTS (K) _--
(4) 1/2" WASHERS (V)
i
\ )(3) 3/8" FLANGE NUTS (BB)
RIGHT BIDE VIEW
STEP 4: (SEE FIGURE 4)
Assemble a shoulder bolt (P) and a 3/8" washer (X)
1o the outside of RH side plate, securing it with a
3/8" flanged nut (BB). Repeat fo_ L.H. side plate.
J
FIGURE 4 RIGHT BiDE VIEW
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 5: (BEE FIGURE 8)
• Remove the bolt, if present, in the hole directly behind
the brake rod on the left side of the tractor frame•
• Attach the L.H. Hanger Bracket (tube facing out) to the
hole using a 5/16" x 3/4" self threading bolt (1)
• Install a round head shoulder bolt (Q) into the hole
that is 9-1/2" to the rear of the bolt you just installed•
Secure it with a 3/8" flange nut (BB) on the inside of
the frame.
BRAKEROD
THREADING BO_(I)
FIGURE8
LN. HANGER i
BRACKET
_8"FLANGEDi
NUT (BB)
LEFT SIDE ViEW
STEP 6: (BEE FIGURE 6)
Remove the bracket, if present, from the hole directly
behind the end of the brake rod on the right side of
the tractor frame Store the bracket and bolt.
• Attach the R.H Hanger Bracket to the hole using a
5/16" x 3/4" serf threading bolt (I).
• Install a round head shoulder bolt (Q) into the hole
that is 9-1/2" to the rear of the bolt you just installed.
Secure it with a 3/8" flange nut (BB) on the inside of
the frame.
5/16" x 3/4" SELF
THREADING BOLT (I)
RIGHT END OF
BRAKE ROD
R.H. HANGER
BRACKET
SHOULDER
BOLT (Q)
1
:1:1_ i
3/8 FLANGED
NUT (BB)
FIGURE 6
RIGHT SIDE ViEW