Leveling The Table Supports - Craftsman 315.220381 Owner's Manual

10 in. stationary radial arm saw
Table of Contents

Advertisement

LEVELING
THE TABLE
SUPPORTS
See Figures 22A and 22B.
The table supportsmust be perfectly level.
Pull the bevel lock lever forward to unlockit. Use
the bevel index knobto rotate the motor so the
arbor shaft points down. Lock the bevel lock lever.
Release the arm lock knob to angle the arm. Begin
by positioningthe arbor shaft over the back of the
highest table support. Normally this is the left side.
See Figure 22A.
Lock the arm lock knob and the carriage lock knob.
Using one of the blade wrenches as a feeler gage,
place it on the table support below the arbor shaft.
With the elevating handwheel, carefully lower the
motor until the shaftjust touches the wrench. The
wrench should move with only slight resistance.
Securely tighten the back screw on the table
support.
Without changing the elevation, move the arm to
place the blade arbor over the front of table sup-
port. See Figure 22B.
ARMLOCKKNOB
Place the wrench below the shaft and check that
the clearance is the same. If not, adjust the table
supportuntil it is the same. Securely tighten the
front screw.
Move the arm to the opposite side and repeat the
above procedure. When the opposite side is level,
recheck the first side to make sure that it is still
accurate and even.
Return the saw and motor to normal height and
position.
BLADE
WRENCH AT
FRONT
Fig. 22B
BEVEL
INDEX KNOB
BEVEL
LOCK LEVER
BLADE WRENCH
AT BACK
BLADE
ARBOR
LEFT SIDE
TABLE SUPPORT
RIGHTSIDE
TABLE SUPPORT
ELEVATING
HANDWHEEL
Fig. 22A
31
[RRF1_NRrRADIALSAW315.220381

Advertisement

Table of Contents
loading

Table of Contents