Specifications; Table Of Contents - Craftsman 137.248830 Operator's Manual

SECTION PAGE
Warranty ........................................ 2
Product Specifications ....................... 2
Power Tool Safety ............................ 3
Table Saw Safety .............................. 4
Electrical Requirements and Safety ...... 5
Accessories and Attachments .............. 6
Tools Needed For Assembly ................ 6
Carton Contents .............................. 6
SECTION PAGE
Know Your Table Saw ....................... 8
Assembly and Adjustments ................. 9
Operation ....................................... 16
Maintenance ................................... 20
Troubleshooting Guide ....................... 21
Parts List ........................................ 22
Push Stick Pattern ........................... 30
FULL ONE YEAR WARRANTY
If this product fails due to a defect in material or workmanship within one year from the date of purchase, Sears will
at its option repair or replace it free of charge.
Contact a Sears Service Centre for replacement.
If this product is used for commercial or rental purposes, this warranty applies only for 90 days from the date of
purchase.
This warranty is in addition to any statutory warranty.
Sears, Roebuck & Co., Dept. 817 WA, Hoffman Estates, IL 60179
[A WARNING I
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals work in a well-ventilated area and work with approved safety equipmentsuch as dust
masks that are spec a y des gned to f ter out m croscop c part c es.
MOTOR
HP (Maximum developed) ..... 3.0
Type .................................. Universal
Amps ................................. 15
Voltage .............................. 120
Hz ...................................... 60
RPM (no load) .................... 5000
Overload Protection ............. YES
[A WARNING I
SAW
Table Size ........................ 26-7/64" x 19-1/2"
Table Extensions ............... 3
- Left,Right,Rear
Extension Rip Capacity ....... 24"
Right
and Left
Blade Size ........................ 10" Diameter
Arbor Size ........................ 5/8" Diameter
Rip Fence
........................ Self Aligning
Miter Gauge ...................... T-Slotted
Maximum Cut Depth @ 90% 3"
Maximum Cut Depth @ 45°.. 2-1/2"
Maximum Dado Cut Width... 1/2"
Net Weight ...................... 65 LBS
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these
rules could result in serious injury to you or damage to the table saw.