The Thunder RWS Series wall speakers can be used in 8Ohm or 100V systems in building sound reinforcement systems to provide
continuous background music. It has a very pleasant sound, with four modes of operation. The speakers are supplied with a
bracket for easy mounting on the ceiling or wall, the bracket is ratchet-mounted so that it can be adjusted to any angle. Its simple
black colour makes it aesthetically pleasing and matches any wall colour. Recommended for sound reinforcement in buildings,
speech amplification and music listening.
INSTALLATION
WARNING: Cabling of a 100 Volt system belongs to an electrical installation which may only be carried out by a qualified
electrician! To avoid electric schock, always switch off the electricity when installing and connecting cables and devices, and
Always insulate the unused connection cables!
Before installation:
choose the appropriate amplifier regarding the operation mode (70V/100V, 8 Ohm), power and number of the speakers
•
•
Plan and choice the best connection method regarding the number, the impedance, and power of the speakers
Installation:
•
Mounting the stable bracket, make sure the
bracket fixed well.
•
Mounting the speaker on the wall to match
the bracket
Installing the plastic knobs up and down.
•
•
Adjusting the angel you want. Tightening
screw, then checking well stable.
CONNECTION
The total load must not exceed the rated power of the amplifier. Before starting the installation, make clear how many speakers
you want to install in the room and with what wattage(s), as overload will damage the amplifier and speaker.
If you are connecting multiple speakers, make sure that all speakers have the same polarity and that the amplifier is not
overloaded. Always make sure that the output signal is not distorted and that your speakers will not get damaged. When
distortions can be heard, either the amplifier or the speaker is overloaded. In order to avoid damage, reduce the volume
immediately when distortions can be heard. When speakers are destroyed by overload, the guarantee becomes void.
8 OHM CONNECTION EXAMPLES
SPECIFICATION
Modell
Type
Woofer
Woofer material
Line Voltage /Impedance
Power (with option):
Frequency response, Sens
Case Material
Dimensions
Weight
The actual values can slightly change from one unit to the other. Specifications can be changed without prior notice.
The device complies the 2014/35/EU Low Voltage Directive and 2014/30/EU Electromagnetic Compatibility Directives
100V/8Ohm wall mounted speaker user guide
Standard setup
RWS-4 (W/B)
4" (10cm)
5W/10W/20W/8Ohm
90Hz - 20kHz @ 88dB
224(dia) x 155 x 134mm
1,2 kg
RWS-4 / 5 / 6 SPEAKERS
Parallel setup
RWS-5 (W/B)
2 way speaker with 1"tweeter
5,25" (13cm)
paper with waterproof paint
70V-100V / 8 Ohm
7,5W/15W/30W/8Ohm
75Hz - 20kHz @ 90dB
ABS with metal grill
260(dia) x 175 x 158mm
1,8kg
1
Serial-Parallel mono setup
RWS-6 (W/B)
6" (15cm)
10W/20W/40W/8Ohm
60Hz - 20kHz @ 90dB
317(dia) x 210 x 210mm
2,6kg