Tool Use And Care Safety; Electrical Safety - Craftsman 320.17541 Operator's Manual

TOOL USE AND CARE SAFETY
Z_ WARNING:
BE SURE to read and understand all instructions before
operating this router. Failure to follow all instructions listed below may result
in electric shock, fire and/or serious personal injury.
1. ALWAYS use clamps or other practical ways to secure and support the workpiece
to a stable platform. Holding the work by hand or against your body is unstable and
may tead to loss of control°
2, DO NOT force the tool. Use the correct tool and bit for your application. The correct
tool and bit will do the job better and safer at the rate for which it is designed°
3o DO NOT use the tool if switch does not turn it "On" or "Off". Any toot that cannot be
controlled with the switch is dangerous and must be repaired.
4o DISCONNECT the plug from the power source before making any adjustments,
changing accessories or storing the tool, Such preventive safety measures reduce
the risk of starting the tool accidentally,
5, NEVER leave the tool running. ALWAYS turn it off. DO NOT leave the tool until it
comes to a complete stop,
6_ STORE idle tools out of the reach of children and other untrained persons. Tools
are dangerous in the hands of untrained users,
7_ MAINTAIN tools with care. Keep cutting tools sharp and clean. Properly maintained
tools with sharp cutting edges are less likely to bind and are easier to control
8. CHECK for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the tool's operation, if damaged, have the tool serviced
before using° Many accidents are caused by poorly maintained tools.
9. USE ONLY accessories that are recommended for this tool. Accessories that may be
suitable for one tool may become hazardous when used on another tool.
ELECTRICAL SAFETY
z_ WARNING:
Do not permit fingers to touch the terminals of plug when
installing or removing the plug from the outlet.
1,
2_
Double insulated tools are equipped with a polarized plug (one blade is wider
than the other).This plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet° Do not chan=gethe plug in any way°
Double insulation [] eliminates the need for the three-wire grounded power
cord and grounded power supply system. Applicable only to Class iI (double-insulated)
tools. This router motor is double insulated,
Z_ WARNING:
Double insulation DOES NOT take the place of normal safety
precautions when operating this tool.
5