Rebuilding The Raid - Asus Z9PE-D8 WS Manual

5.3.6

Rebuilding the RAID

This option is only for the RAID 1 set.
Rebuilding the RAID with other non-RAID disk
If any of the SATA hard disk drives included in the RAID 1 array failed, the system
displays the status of the RAID volume as "Degraded" during POST. You can
rebuild the RAID array with other installed non-RAID disks.
To rebuild the RAID with other non-RAID disk:
1. At the prompt, press <Ctrl> + <I> to enter the Intel Rapid Storage Technology
option ROM utility.
2. If there is a non-RAID SATA Hard Disk available, the utility will prompt to
rebuild the RAID. Press <Enter>, and then use up/down arrow keys to select
the destination disk or press <ESC> to exit.
"Degraded" volume and disk available for rebuilding detected. Selecting
a disk initiates a rebuild. Rebuild completes in the operating system.
Select the port of destination disk for rebuilding (ESC to exit):
Port Drive Model
X
Select a destination disk with the same size as the original hard disk.
5-32
[ DEGRADED VOLUME DETECTED
Serial #
XXXXXXXXXXX XXXXXXXX
[ ↑↓ ]-Previous/Next
]
Size
XX.XGB
[ENTER]-Select [ESC]-Exit
Chapter 5: RAID configuration