Page 1
OPERATION MANUAL AIR CONDITIONER Duct type □ ARTH18KMTAP □ ARTH24KMTAP □ ARTH30KMTAP □ ARTH36KMTAP □ ARTH45KMTAP □ ARTH54KMTAP MODEL: * Check the model name. (Refer to the rating label.) REFRIGERANT This Air Conditioner contains and operates with refrigerant R32. THIS PRODUCT MUST ONLY BE INSTALLED OR SERVICED Before using this product, read these instructions BY QUALIFIED PERSONNEL.
[Original instructions] Contents Explanation of symbols displayed on the indoor unit or outdoor unit. 1. SAFETY PRECAUTIONS .......... 1 WARNING 2. BASIC OPERATIONS ..........2 This symbol shows that this product uses a low 3. AIRFLOW SETTINGS ..........3 burning velocity material. If the refrigerant is leaked 3.1.
2. BASIC OPERATIONS WARNING • Do not move this product by holding the indoor unit pipes. NOTE: For detailed instructions on how to operate, refer to the (The stress applied to the pipe joints may cause the operation manual of the remote controller. fl...
NOTES: • The operation modes will be the same as the mode at the last time operation was stopped. So Cooling → Heating → Cooling → • Set the temperature higher than the current room temperature, Heating type of operations cannot be set automatically. otherwise, the operation will not operate.
(1) Contact your electricity supplier to check whether they are activating the DR mode. (2) Is the air conditioner under the Demand controlling? Contact your electricity supplier. No • Contact Fujitsu General (AUST.) PTY LIMITED. (Refer to Hooks Hooks your warranty card.) 3.
Install the air fi lters 7. GENERAL INFORMATION (1) Fit the right air fi lter to the 4 hooks on the indoor unit. Hooks ■ Inverter On start-up, the air conditioner will operate at maximum capacity to bring the room quickly down to the desired temperature. Once the temperature in the room begins to achieve the set temperature, the air conditioner will reduce its capacity and energy usage to the minimum capacity and input ratings.
■ When indoor and outdoor temperatures are Simultaneous Use of Multiple Units high ● When using a multi-split type air conditioner, the multiple indoor units When both indoor and outdoor temperatures are high during the use of can be operated simultaneously, but when 2 or more indoor units of the Heating mode, the outdoor unit’s fan may stop at times.
9. TROUBLESHOOTING □ <In the Heating mode> Have you just started the operation? In this case, the fan rotates at a very low speed temporarily to warm up the internal parts of the unit. WARNING □ <In the Heating mode> Is the room temperature higher than the set temperature? In following events, immediately stop operation of the In this case, the outdoor unit stops and the indoor unit fan rotates...