Page 1
BenQ-Siemens / HHB-183, HHB-188 1.Power on a)Long press the power button for 1 seconds while the headset is power off, the headset will start. The blue LED light slowly flashes once every 2 second. 2. Pair a) The headset should be paired before first time use.
Page 2
It can control some media player softwares in using process. i. Press the call button can realize the “Play/Pause” function. ii. Press the vol+ button can realize the “Previous” function. iii. Press the vol- button can realize the “Forward” function. The headset can control the volume.
Page 3
headset with the PC while it is connected to the Headset profile. Press the vol+ button to increase the volume of Speaker iii. Press the vol- button to decrease the volume of Speaker Chat softwares can be used to talk. 5.
Page 4
is an incoming call. Press the play/pause button to end the call while talking. Long press the play/pause button to refuse an incoming call while talking. Long press the call button to redial the latest calling number while idle. vii. Press the call button to enter the “voice dial”...
Page 5
mobile phones and the latest time is when the mobile phone starts calls officially, it can be operated as the afmd Point 5. h) Continue to listen to MP3 when call ends and go back to A2DP. 7. Power off Long press the power button for three second while it is power on.The red LED light flashes.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.