GE GXSL55R Owner's Manual And Installation Instructions page 6

Performance Data Sheet.
SmartWater Filtration System GXSV65R Using Filter FQSVF
■ This System has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the indicated
substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system,
as specified in NSF/ANSI 42 and 53.
■ Actual performance may vary with local water conditions.
WARNING:
Do not use with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
USEPA
Parameter MCL
Chlorine —
T & O —
Particulate** —
Turbidity 0.5 NTU***
Cysts 99.95% red.
Asbestos 99% red.
Lead, pH 6.5 0.010 mg/L
Lead, pH 8.5 0.010 mg/L
Mercury, pH 6.5 0.002 mg/L
Mercury, pH 8.5 0.002 mg/L
Lindane 0.0002 mg/L
Benzene 0.001 mg/L
Atrazine 0.003 mg/L
VOC Reduction
Chloroform 0.080 mg/L
*Tested using a flow rate of 0.60 gpm (2.27 l/min); pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F (20° ± 3°C)
**Measurement in particles/mL. Particles used were 0.5–1 microns.
***NTU—Nephelometric Turbidity Units / NTU—unités de turbidité néphélométrique
Operating Specifications / Spécifications d'opération
Capacity: certified for up to 160 gallons (605 l); up to six months
Pressure requirement: 35–120 psi (2.8–8.2 bar)
Temperature: 33–100°F (0.6–38°C)
Flow rate: 0.60 gpm (2.27 l/min)
Replacement Filter Canisters/Estimated Replacement Costs
FQSVF—Replacement filter canister $35–40
For replacement parts, call toll-free 800.626.2002 (U.S.),
800.663.6060 (Canada–English), 800.361.3869 (Canada–French)
6
Influent Influent
Challenge Concentration Average
2.0 mg/L + 10% 2.00 mg/L
—
> 10,000 particles/mL 4,100,000 #/mL
11 + 1 NTU*** 11.00 NTU
Min. 50,000/L 140,000 #/L
— 280 MF/L
0.15 mg/L + 10% 0.150 mg/L
0.15 mg/L + 10% 0.140 mg/L
0.006 mg/L ± 10% 0.0065 mg/L
0.006 mg/L ± 10% 0.0059 mg/L
0.002 mg/L ± 10% 0.00193 mg/L
0.015 mg/L ± 10% 0.014 mg/L
0.009 mg/L ± 10% 0.00873 mg/L
0.300 ± 10% 0.340 mg/L
Standard No. 42: Aesthetic Effects
Effluent
Average
<0.05 mg/L
— —
76,500 #/mL 110,000 #/mL
Standard No. 53: Health Effects
0.1 NTU
1 #/L
<0.17 MF/L
<0.001 mg/L <0.001 mg/L
<0.001 mg/L <0.001 mg/L
<0.0002 mg/L <0.0002 mg/L
<0.0002 mg/L <0.0002 mg/L
<0.00002 mg/L 0.00005 mg/L
<0.0005 mg/L <0.0005 mg/L
<0.0005 mg/L <0.0005 mg/L
0.00098 mg/L 0.00620 mg/L
% Reduction
Maximum Average
<0.05 mg/L >97.50%
— —
98.10%
0.1 NTU 98.80%
1 #/L >99.99%
<0.17 MF/L >99.00%
>99.30%
>99.30%
96.60%
96.60%
>98.80%
>96.40%
>94.10%
97.90%
Maximum Permissible
Product Water
Concentration
Minimum
>97.50% >50%
— —
97.30% >85%
98.20% 0.5 NTU
>99.99% 99.95%
>99.00% 99%
>99.30% 0.01 mg/L
>99.30% 0.01 mg/L
>96.70% 0.002 mg/L
>96.70% 0.002 mg/L
98.80% 0.0002 mg/L
>96.40% 0.005 mg/L
>94.10% 0.003 mg/L
98.20% 95%