Craftsman 358.797921 Operator's Manual page 11

Gas powered blower
Table of Contents

Advertisement

8. Move away from the i_el tank and melt the ends of
the rope.
9. Allow each melted end to drip once; then while the
rgpe is still hot, pull each melted end through a
dean rag to obtain a smooth, pointed end.
t0. Insert one end of the rope through the handle and
secure with a knot. Leave 3/lb _ pigtailbehind the
knot. _gure
18 (Inset).
11.insert the other end of the rope through the meta!
grommet, then under the Rope Guide, l_igure 18.
12,Guide He
inside the pulley, then through Pulley
Hole. Figure
17.
13,Wrap rope counterciock_se
around the pulley
• ra_het
and tuck the loose end bac__ und_,t_e
rope, l eaving a bouta Iinchtail next_
Retain-
er-P_b. Figure19.
14.Install
and tighten
the Retainer Screw/Washer.
Figure17.
.
Do not overtighte_ the Retainer Screw.
Over tightening
the s_.ew can cause the screw
post-to_strip ouL Tightdn the screw untilthe bgt-
tom of the washer either (1) is snug against the
rope or (2) contacts the top of the screw pest,
IS,Ptfll the rope tightly around the FRlley ratchet.
!6_Sllghfiyp _uI[the rope to relieve the premsuroon the
hex wr#'hch. Remove thehex wr_ch and allow.
the rope_torewi_
slowly.
17,t_assemb_
the _lley
Housing to the engine,
Tighten screwssecurely.
_eBe
sure tl_e r ubber O-Ring._
h_talled
_ey
housing. See__,,
ls._JJgn theh_i.
the._pener _
the_p_er
When _l_
the Impeller Hous-
ing
to the Engine Sl_. u_ be sure not to over-
tighten screws. Overtigh_
the screws can
strip out the Impet_r Housing.
19,Assemble
parts by reversing
steps 1. through 4.
•Pulley Ratchet
'Hole
Pulle_
.|
lOt_
lie ! I
Rope Retainer
H0using NotchScrew/Washer
------_--
17 . ...
• _
Rope
w
Grommet
Screw
Figure18
,Rope
Retainer
- II -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

358.797950358.797982358.797922358.797961

Table of Contents