Advertisement
Available languages
Available languages
2
Remove the vacuum tube assembly.,
3
Remove the debris from impeller
Mades..
4
Check the impeller for any signs of
damager If it is damaged, contact your
Sear Service Center (refer to the back
cover).
5_
Install the vacuum tube or, if you want
to switch to blower mode, the bottom
inlet cover, Refer to Converting from
Blower to Vacuum or Converting from
Vacuum to Blower for more information.
Store the blowedvacuum
and extension cord indoors, in a cool dry location, out of reach
of children and animals..
Problem
Appliance does not
operate.,
Appliance vibrates
Possible
Cause
t
Switch is in the Off
position..
2
The inlet cover or vac
tube is not locked in
place..
3. The power cord is
disconnected,
abnormally, makes an
abnormal noise, or the
impeller does not turn
freely
4.. Mechanical failure
1. Debris is caught in the
impeller
2, Mechanical failure
Corrective
Action
Turn the switch to On,
1,,
2., Ensure that the bottom
inlet cover or vacuum
tube is locked in place,
3, Ensure that the
extension cord is fully
connected to the blower
and the power supply,
4, Contact Sears Service
(see back cover),
Turn off the appliance,
disconnect the power
supply and, remove the
debris from the impeller
(refer to Removing
Clogged Debris from
the Impeller)
2
Contact Sears Service
(see back cover),.
Advertisement
