Page 1
CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET BEFORE USING THE DRYER / CONNECTIONS ELECTRICAL CONNECTION PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE DRYER...
BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations.
PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol 2. Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy.
DESCRIPTION OF THE DRYER Work top. Water Container bottom version or Water Container top version. Contact pin. Door: To open the door: pull the handle. To close the door: push gently until closed. Filter. Child Safety Lock. Button for heat exchanger flap opening.
DRAINAGE SYSTEM For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: Normally the drain hose is not supplied; the accessory AMH 883 kit, available at your dealer or our After Sales Service, should be used.
DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility Unplug the dryer. Open the door. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it. Unscrew the 2 screws of the door hinge and remove the door. Removing the door lock: Unscrew the 2 screws above and below the door lock system.
HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every three months, proceeding as follows: Open the door and press the heat exchanger flap button on the bottom of the door entrance. The heat exchanger flap opens.
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide If a fault occurs, before contacting our After- Sales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough: Was the correct programme selected? Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm? When the spinning speed is less than 800 rpm the water...