Cornelius Series 200 Service Manual page 20

Self-Contained Flaked Ice Maker Service Manual
Water leaks.
Excessive noise or
chattering.
Machine runs with full bin
of ice.
Unit off on reset.
Unit goes off on reset.
Publication Number: 166240010SER
D. "O" ring leaking at bottom of
evaporator shell
E. Compressor not running
A. Worn or bad float valve
B. Float and arm assembly stuck
C. "O" ring leaking at bottom of
evaporator shell
D. Storage bin drain and tubing
A. Mineral or scale deposits on
inside of evaporator shell
B. Intermittent water supply
C. Water level in float tank too low
D. Auger gearmotor end-play or
worn bearings
E. Air lock in gravity water supply
line from float tank to evaporator
shell
A. Storage bin thermostat set too
cold
B. Bin thermostat thermowell out
of path of ice
A. Ice jams up in evaporator shell
B. Bin thermostat will not shut-off
machine. Set too cold.
C. Auger motor has worn
bearings
A. Ice chute out of alignment,
restricted ice flow out of
evaporator section
B. Ice chute center separator bent
restricting ice flow out of
evaporator section
C. Incoming water temperature
too cold
D. Bin thermostat does not shut-
off when bin is full of ice
E. Mineral or scale deposits on
inside of evaporator shell and
evaporator
F. Strips loose or missing on
inside of evaporator shell
- 16 -
D. Check and replace "O" ring
E. Check and replace "O" ring
A. Check and replace
B. Check and replace
C. Check and replace
D. Check and repair
A. Remove and clean inside
surfaces by immersing
evaporator shell in ice machine
cleaner
B. Check inlet water line
C. Check and adjust water
level
D. Repair or replace
E. Check and adjust warmer
A. Check and adjust warmer
B. Adjust thermowell
A. Clean inside surface of
evaporator shell
B. Check and adjust or replace
C. Check and replace
A. Re-align
B. Replace ice chute
C. Maintain temperature above
50 F
D. Replace bin thermostat if
necessary
E. Inspect and clean
F. Inspect and replace
evaporator shell if necessary
© 2004, IMI Cornelius Inc.