Download Print this page
Sony CDX-565MXRF Installation/Connections
Hide thumbs Also See for CDX-565MXRF:

Advertisement

Quick Links

Compact Disc
Changer System
Installation/Connections
Installation/Connexions
CDX-565MXRF
Sony Corporation © 2002
Parts list
The numbers in the list are keyed to those in the
instructions.
1
2
2
6
5
CD changer
Choose the mounting location carefully,
observing the following:
— The unit is not subject to temperatures
exceeding 55°C (131°F) (such as in a car
parked in direct sunlight).
— The unit is not subject to direct sunlight.
— The unit is not near heat sources (such as
heaters).
— The unit is not exposed to rain or moisture.
— The unit is not exposed to excessive dust or
dirt.
— The unit is not subject to excessive vibration.
— The fuel tank should not be damaged by the
tapping screws.
— There should be no wire harnesses or pipes
under the place where you are going to
install the unit.
— The spare tire, tools or other equipment in or
under the trunk should not be interfered
with or damaged by the screws or the unit
itself.
Notes
• Be sure to use only the supplied mounting
hardware for a safe and secure installation.
• Use only the supplied screws.
• Make holes of ø3.5 mm (
5
/
in.) only after making
32
sure there is nothing on the other side of the
mounting surface.
Wired remote
•Avoid mounting it where it may:
— hinder normal driving activities.
— block the airbag (especially passenger-side)
in operations.
— jeopardize the passengers.
— be exposed to hot air from the heater.
— be exposed to direct sunlight.
•After installing the unit, make sure the whole
unit can be operated by the wired remote.
3-241-727-11 (1)
Printed in Thailand
Liste des composants
Les numéros de la liste correspondent à ceux des
instructions.
3
4
4
4
7
Changeur de CD
Choisir l'emplacement de montage en tenant
compte des observations suivantes :
— Appareil non soumis à des températures
dépassant 55°C (131°F) (comme dans une
voiture garée au soleil).
— Appareil non soumis au rayonnement solaire
direct.
— Appareil à l'écart de sources de chaleur
(comme des radiateurs).
— Appareil non exposé à la pluie ou à
l'humidité.
— Appareil non exposé à des poussières ou à
des souillures en excès.
— Appareil non exposé à des vibrations
excessives.
— Vérifier que le réservoir d'essence ne risque
pas d'être endommagé par les vis
taraudeuses.
— Il ne doit pas y avoir de faisceau de fils ou de
tuyaux à l'emplacement du montage.
— Vérifier que l'appareil ou les vis ne risquent
pas d'endommager ou de gêner la roue de
secours, les outils, ou autre objet dans le
coffre.
Remarques
• Pour garantir la sécurité de l'installation, utilisez
uniquement le matériel de montage fourni.
• Utilisez uniquement les vis fournies.
• Ne percez les trous de 3,5 mm ø (
5
/
po.) qu'après
32
vous être assuré que rien ne se trouve de l'autre
côté de la surface de montage.
Télécommande à fil
•Evitez de l'installer dans des endroits où elle
pourrait:
— gêner la conduite normale du véhicule ;
— bloquer le fonctionnement du coussin
gonflable (airbag) (surtout côté passager) ;
— mettre les passagers en danger ;
— exposé à l'air chaud d'un chauffage ;
— exposé au rayonnement direct du soleil.
•Après avoir installé l'appareil, assurez-vous
que l'appareil peut être contrôlé au moyen de
la télécommande filaire.

Advertisement

loading

Summary of Contents for Sony CDX-565MXRF

  • Page 1 Compact Disc Changer System Installation/Connections Installation/Connexions CDX-565MXRF Sony Corporation © 2002 Printed in Thailand Parts list Liste des composants Les numéros de la liste correspondent à ceux des The numbers in the list are keyed to those in the instructions.
  • Page 2 Installation How to install the CD changer •When you install the CD changer, be careful not to damage wiring or equipment on the other side of the mounting surface. •The brackets 1 provide two positions for mounting, high and low. Use the appropriate screw holes according to your preference.
  • Page 3: Reset Button

    Connections Caution •This unit is designed for negative ground 12 V • Be sure to connect the red power input lead to the DC operation only. positive 12 V power terminal which is powered •Before making connections, turn the car ignition when the ignition switch is in the accessory off to avoid short circuits.
  • Page 4: Changing The Output Level

    Wired remote (RM-X83RF)/Télécommande à fil (RM-X83RF) AMS/ENTER dial Note Remarque The supplied wireless remote (RM-X84RF) can be La télécommande sans fil fournie (RM-X84RF) se operated almost like the wired remote (RM-X83RF). manipule pratiquement comme la télécommande filaire (RM-X83RF). Changing the transmitting Changement de la fréquence de frequency transmission...

This manual is also suitable for:

Cdx-565mxrf installation/connection