OM-CP-RHTEMP101A Product Notes LEDs - Green LED blinks: 10 seconds to indicate logging and 15 seconds to indicate delay start mode - Red LED blinks: 10 seconds to indicate low battery and/or memory and 1 second to indicate an alarm...
OM-CP-RHTEMP101A Connecting the data logger - Once the software is installed and running, plug the interface cable into the data logger. - Click the Communication Menu, then Auto Configure Port. - After a moment, a box will appear stating a device has been found.
Page 4
WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY LEAK OR EXPLODE IF HEATED ABOVE 60°C (140°F). Specifications subject to change. See Omega’s terms and conditions at www.omega.com...
Page 5
Fax: (203) 359-7700 e-mail: info@omega.com For Other Locations Visit omega.com/worldwide The information contained in this document is believed to be correct, but OMEGA accepts no liability for any errors it contains, and reserves the right to alter specifications without notice. WARRANTY/DISCLAIMER OMEGA ENGINEERING, INC.