About Cable Select - Plextor PX-504A Installation And User Manual

Before PX-504A Installation
D System uses special Cable Select
cables; all devices are jumpered for
Cable Select.
Figure 9: How to Install the PX-504A If Your Computer Is Originally Set Up in

About Cable Select

The Cable Select jumper position sets the PX-504A drive to use the CSEL signal
from the IDE interface for configuration purposes. This signal automatically selects
the correct Master/Slave setting for the drive.
Figure 10: Configuring the PX-504A Drive for Cable Select
To use CSEL, you must have:
• A computer that supports CSEL.
• A special CSEL (Cable Select) cable for IDE.
Section 2. Installing Your PX-504A
How to Install the PX-504A
Set the PX-504A's mode jumper to
CSEL, and connect the drive to the
end of the cable from the computer's
IDE interface connector.
Configuration D
PX-504A Installation and Users Manual
15