Boosting The Bass; Front Image Enhancer (F.i.e.); Adjusting Source Levels - Pioneer Super Tuner III DEH-P3900MP Operation Manual

Cd receiver
Hide thumbs Also See for Super Tuner III DEH-P3900MP:
Table of Contents

Advertisement

Available languages

Available languages

Section
09
Audio Adjustments
2
Press a to turn high pass filter on.
HPF : 80 appears in the display. High pass fil-
ter is now on.
# If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of HPF : 80.
# To turn high pass filter off, press b.
3
Press c or d to select cut-off frequency.
50—63—80—100—125 (Hz)
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.

Boosting the bass

Bass boost function boosts the bass level of
sound lower than 100 Hz. The more the bass
level is increased, the more the bass sound is
emphasized and the entire sound becomes
powerful. When using this function with the
subwoofer, the sound under the cut-off fre-
quency is boosted.
1
Press AUDIO to select BASS.
# You can also select the bass boost setting by
pressing and holding SW.
2
Press a or b to select a desired level.
0 to +6 is displayed as the level is increased or
decreased.

Front image enhancer (F.I.E.)

The F.I.E. (Front Image Enhancer) function is a
simple method of enhancing front imaging by
cutting mid- and high-range frequency output
from the rear speakers, limiting their output to
low-range frequencies. You can select the fre-
quency you want to cut.
32
En
Precaution
When the F.I.E. function is deactivated, the rear
speakers output sound of all frequencies, not just
bass sounds. Reduce the volume before disenga-
ging F.I.E. to prevent a sudden increase in vo-
lume.
1
Press AUDIO to select FIE.
# When the rear output setting is R-SP :S/W,
you cannot select FIE.
2
Press a to turn F.I.E. on.
# To turn F.I.E. off, press b.
3
Press c or d to select a desired fre-
quency.
100—160—250 (Hz)
Notes
! After turning the F.I.E. function on, use the bal-
ance adjustment (refer to page 29) and adjust
front and rear speaker volume levels until they
are balanced.
! Turn the F.I.E. function off when using a 2-
speaker system.

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.
1
Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2
Press AUDIO to select SLA.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Deh-p390mp

Table of Contents