Wireless Communication; Connecting Peripherals - Panasonic Toughbook CF-H1ADBAZCM Reference Manual

Troubleshooting (Advanced)

Wireless Communication

Cannot connect to a network.
Access point is not detected.

Connecting Peripherals

An error occurs while installing the
driver.
Wireless switch
Set the device ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enabled] in
the [Advanced - Wireless Configuration] menu of the Setup Utility (
Disable the Wireless Connection Disable Utility (
Restart the computer.
Shorten the distance between the computer and the access point, and try the
detection again.
Confirm the following settings:
• [Wireless LAN] in the [Advanced - Wireless Configuration] menu of the Setup
Utility
Confirm that [Wireless LAN] is set to [Enabled]. (
Wireless switch
• Wireless Switch Utility
Confirm that Wireless LAN is ON.(
This computer uses channels 1 through 11
the channel being used by the access point.
*1
In the case of wireless communications, the frequency band being used can be divided
into segments, so that different communications can be conducted on each band seg-
ment. A "Channel" refers to the individual frequency bandwidth divisions.
When you install a driver of card or peripheral device, make sure that the driver
is compatible with the operating system. If it is not compatible, malfunction may
occur. For information about the driver, contact the manufacturer of the periph-
eral device.
103
page 75)
page 86)
page 74)
*1
when using IEEE802.11b/g. Check
page 86).