Page 1
PT-AX200 P ro d u c t N u m b e r : High-Definition Home Cinema Projector P ro d u c t N a m e : As of October 2008. Specifications subject to change without notice. < 1 >...
PT-AX200 High-Definition Home Cinema Projector Specifications Main Unit Power supply: 100–240 V AC, 50/60 Hz Power consumption: 290 W (0.08 W in standby mode with fan stopped) LCD* panel: Panel size: 0.7˝ diagonal (16:9 aspect ratio) Display method: Transparent LCD panel (x 3, R/G/B)
Page 3
PT-AX200 High-Definition Home Cinema Projector Power cord length: 3 m (9´10˝) Cabinet material: PC + ABS Dimensions (W x H x D): 395 x 112 x 300 mm (15-17/32˝ x 4-13/32˝ x 11-25/32˝) * Weight: 4.9 kg (10.8 lbs) Operating temperature: 0°–...
Page 4
PT-AX200 High-Definition Home Cinema Projector Dimensions unit : mm (inch) NOTE: This illustration is not drawn to scale. (4-21/16) (15-17/32) (12-5/32) Terminals 1 Serial input 2 HDMI 1 input 3 HDMI 2 input 4 Computer input 5 Component (Y/P ) Input...
Page 5
PT-AX200 High-Definition Home Cinema Projector Standard setting-up positions Ø49 (1-15/16˝) Ø43 (1-11/16˝) Projected image (7-1/16˝) unit : mm (inch) Lower edge of projected image (2-3/4˝) NOTE: Illustrations show the projector installed Projected image using optional ceiling bracket ET-PKX200. This illustration is not drawn to scale.
Page 6
PT-AX200 High-Definition Home Cinema Projector Shift range Optical axis shift function allows to shift the position of a projected image as shown below. (Width of projected image) 0.25H 0.25H Standard position of projected image Installable angle Install the projector at an angle within the range shown below.
PT-AX200 High-Definition Home Cinema Projector Computer data compatibility This projector accepts up to 70 kHz horizontal scanning frequency and 108 MHz dot clock. NOTE: The display resolution of this projector is 1280 x 720 pixels. If the display resolution indicated in the above data does not match this resolution, the input signal will be converted to 1280 x 720 pixels.
Page 8
PT-AX200 High-Definition Home Cinema Projector Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, com- mands must be input through communication software, based on the format and satisfying the commu- nication conditions shown below.
PT-AX200 High-Definition Home Cinema Projector Control commands Command: <Parameter> Callback: <Parameter> Parameter value Function Power on (standby mode on) – – Power off (standby mode off) – – Input signal selection IIS:<input signal > IIS:<input signal> – The same function as “DEFAULT” button –...
PT-AX200 High-Definition Home Cinema Projector Parameter format Parameter format Size (Byte) Difinition <off_on> 0 = off, 1 = on <input signal> VID = video, SVD = S-video, RG1 = computer, YUV = YP HD1 = HDMI 1, HD2 = HDMI 2 <power condition>...
Page 11
PT-AX200 High-Definition Home Cinema Projector Notes on Projector Placement and Operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. Never place objects on top of the projector while it is operating.