Panasonic KX-TS500B User Manual

1
1-A Location of controls
Integrated Telephone System
DIALING MODE Selector
Operating Instructions
(1-B)
RINGER Selector
KX-TS500B
(1-B)
Model No.
KX-TS500W
Pulse-or-tone dialing capability
($) (TONE) Button (3-B)
Accessories (included)
∑ Handset. . . . . . . one
Order No.
KX-TS500W
PQJXE0401Z (Black)
PQJXE0411Z (White)
PLEASE READ BEFORE USE AND SAVE.
Panasonic World Wide Web:
≥For extra orders, call
http://www.panasonic.com
1-800-332-5368.
for customers in the USA or Puerto Rico
4
Attach your purchase receipt here.
For your future reference
4-A Wall Mounting
Serial No.
The unit can be mounted on a wall phone plate.
(found on the bottom of the unit)
1
Press the tabs in the direction of the arrows
(1), then remove the wall mounting adaptor
Date of purchase
(2).
Name and address of dealer
If you need assistance with the set-up or
operation,
please call 1-800-211-PANA(7262)
2
Tuck the telephone line cord inside the wall
mounting adaptor, and push it in the
direction of the arrow (1 and 2).
Panasonic Consumer Electronics Company,
≥The word
Division of Matsushita Electric Corporation of
America
One Panasonic Way, Secaucus, New Jersey 07094
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5, San Gabriel Industrial
Park Carolina, Puerto Rico 00985
Printed in USA PQQX13857YA F0703-1073 D

Getting Started

1-B Settings
VOLUME (^), (_) 1
Connect the telephone line cord (1).
Buttons (2-A)
2
Connect the handset cord (2), then confirm
the dial tone.
Single-Line
Telephone Jack (RJ11C)
(FLASH) Button
(3-A)
(REDIAL) Button (2-A)
∑ Handset Cord. . . one
Order No.
PQJA212N (Black)
PQJA212M (White)
∑ Telephone Line Cord
Handset Cord
. . . . . . . . . . . . . one
Order No.
PQJA10075Z

Things You Should Know

3
Connect the telephone line cord. Mount the
unit, then slide down.
≥Fasten the cord to prevent it from being
disconnected.
2
1 1
Hooks
" "
UP WALL should face upward.
2
1
For assistance, please call: 1-800-211-PANA(7262)
3
Set the DIALING MODE selector to TONE.
≥If you cannot dial, set to PULSE.
DIALING MODE
TONE PULSE
4
Telephone Line Cord
Set the RINGER selector to HIGH, LOW or
1 OFF.
(Ex. "LOW" is selected.)
DIALING MODE
Selector
RINGER
HIGH OFF
RINGER Selector
2
Handset ≥When set to OFF, the unit will not ring.
4-B Troubleshooting
Problem
The unit does ≥Check the settings (1-B).
not work.
The call cannot ≥Check whether the DIALING
Wall Phone
be connected MODE selector setting is
Plate
even if you correct or not (1-B).
dialed correctly.
The unit does ≥The RINGER selector is set
not ring. to OFF. Set to HIGH or LOW
(1-B).
If you cannot ≥Call our customer call center
solve your at 1-800-211-PANA(7262).
problem ≥Panasonic's e-mail address
for customer inquiries:
consumerproducts@panasonic.com
for customers in the USA or
To temporarily set the
Puerto Rico ONLY
handset down during
a conversation, place
it as shown here.
For assistance, please call: 1-800-211-PANA(7262)
2 Operation
2-A Making Calls
1
Lift the handset.
2
Dial a phone number.
≥If you misdial, hang up and start again from
step 1.
3
When finished talking, hang up.
To redial the last number dialed
Lift the handset. ➡ Press
(REDIAL)
.
To adjust the receiver volume (6 levels)
while talking
(^).
To increase, press
(_).
To decrease, press
≥After hanging up, the volume level will be saved.
2-B Answering Calls
1
When the unit rings, lift the handset.
2
When finished talking, hang up.
4-C Helpful Information
≥Environment—do not place the unit in a room
Remedy
where the temperature is less than 5oC (41oF) or
greater than 40oC (104oF). Allow 10 cm (4z)
clearance around the unit for proper ventilation.
Avoid excessive smoke, dust, mechanical
vibration, shock, or direct sunlight.
≥Routine care—wipe the unit with a soft cloth. Do
not use benzine, thinner, or any abrasive powder.
≥If there is any trouble—disconnect the unit from
the telephone line and connect a known working
phone. If the known working phone operates
properly, have your unit repaired by one of the
authorized Panasonic Factory Service Centers. If
the known working phone does not operate
properly, consult your telephone company.
For product service
≥Call 1-800-211-PANA(7262) or 1-800-833-9626 for
the location of an authorized servicenter.
≥Panasonic's e-mail address for customer inquiries:
consumerproducts@panasonic.com
for customers in the USA or Puerto Rico ONLY
3

Special Features

3-A For Call Waiting Service Users
(FLASH)
Press if you hear a call-waiting tone
while talking.
≥The first call is put on hold and you can answer the
second call.
≥To return to the first caller, press (FLASH) again.
3-B Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press ($) (TONE) before entering access
numbers which require tone dialing.
≥The dialing mode changes to tone. You can enter
numbers to access answering services, electronic
banking services, etc. When you hang up, the
mode will return to pulse.
≥Access numbers entered after pressing ($)
(TONE) will not be included when redialing.
When you ship the product
≥Carefully pack your unit, preferably in the original
carton.
≥Attach a letter, detailing the symptom, to the outside
of the carton.
Symptom
≥Send the unit to an authorized servicenter, prepaid and
adequately insured.
≥Do not send your unit to the Panasonic Consumer
Electronics Company listed on the back cover or to
executive or regional sales offices.
These locations do not repair consumer products.
4-D Specifications
Power Source: From telephone line
Dimensions (H x W x D):
Approx. 96 mm x 150 mm x 200 mm
25 29 7
(3 ⁄ q k 5 ⁄ q k 7 ⁄
q)
32 32 8
Mass (Weight): Approx. 475 g (1.05 lb.)
Dialing Mode: Tone (DTMF)/Pulse
Operating Environment: 5°C – 40°C (41oF – 104oF)
Specifications are subject to change without notice.