CompuSTAR 1W900FMR – PRO User Manual page 3

Key Button (2.5 Sec.) – Holding the Key Button for 2.5 seconds activates the remote start feature on your
system. The vehicle will flash the parking lights once. Once the vehicle is remote started then the parking
lights will come on solid. You have the option of having your parking lights flash during remote start.
Holding the Key Button again for 2.5 seconds while your vehicle is remote started will deactivate the
remote start and flash the parking lights twice.
Lock Button + Unlock Button (0.5 Sec.) – Siren On/Off – Tapping these two buttons at the same time will
mute the siren chirps during arm/lock and disarm/unlock. This feature will also mute the siren when the
siren is set to 20 chirp silent siren. Your parking lights will flash once when you tap this button to turn this
feature off and twice to turn this feature on.
Valet Mode - There are three different ways to enter Valet mode.
1) Lock and Trunk Buttons together for a half second while the vehicle's ignition is on. Your installer
can change these settings so that you do not have to turn ignition on. Your parking lights will flash once
when you tap these buttons to turn this feature on and twice to turn this feature off.
2) Ignition On and Off for 5 times with key
3) Secure Valet – Consult your installer for this feature. If your installer turns on Secure Valet option,
you can put the system into Valet mode with the valet/LED button by following steps 3-5 below. You can
change the valet code numbers as follows:
1. Your installer must program Option 3-10 to Setting 3.
2. Turn key to the ignition on position.
3. Hold down valet switch for 1.5 seconds. LED on switch will begin to flash rapidly.
4. Tap the button on the switch to enter first number of 2-digit code. LED will flash the first number slowly.
5. Once the LED begins flashing rapidly tap the button on the switch to enter the second number.
6. Turn ignition off and Valet Switch is now programmed.
7. To enter valet mode follow steps 3 to 5
Lock + Trunk Button (2.5 Sec.) – When you hold these two buttons together for 2.5 seconds you can
disable your shock sensor. Your parking lights will flash once when you tap these buttons to turn this
feature on and twice to turn this feature off. This also disables any other added sensors such as radar,
proximity or tilt sensors.
Lock + Key Button (0.5 Sec.) – Drive Lock On/Off – Tapping the Lock and Key Buttons at the same time
will turn on the "Drive Lock" feature on your system. Your parking lights will flash once when you tap
these buttons to turn this feature on and twice to turn this feature off.
Your CompuStar dealer must also set this option in the option menu. This feature locks your vehicle when
you turn the ignition on and press the foot brake or accelerate. The CompuStar will unlock your vehicle
when you turn the key off or set the emergency brake. (manual transmissions only)
Unlock + Trunk Button (0.5 Sec.) – Passive Arming On/Off – Tapping the Unlock and Trunk Buttons at the
same time turns Passive mode on. Your parking lights will flash once when you tap these buttons to turn
this feature on and twice to turn this feature off. With Passive mode on, your vehicle will lock and arm 30
seconds after the door is opened and closed. The parking lights will flash and/or siren will chirp every 10
seconds up to 30.
3