Specifications; Low Battery Warning; The Reset Button; Maintenance - Oregon Scientific BAR338PA User Manual

Rf projection barometer with remote thermo sensor
Hide thumbs Also See for BAR338PA:
Table of Contents

Advertisement

LOW BATTERY WARNING

When it is time to replace batteries, the low-battery indicator will
appear. Replace the batteries for the main unit when the indicator
appears on the clock window. Do the same for the remote unit when
the indicator appears below the OUT icon.
CAUTION: Batteries contain dangerous chemicals and may leak,
explode or otherwise cause injury and damage if not hadled
properly. Do not mix old batteries with new as this may result in
leakage. Only insert batteries with the polarities in the directions
as shown in this manual. Always dispose of batteries properly.

THE RESET BUTTON

The [RESET] button is used to enhance synchronization of signals
after battery replacement. Note that when RESET is pressed all user-
selected settings will be cleared and the unit will return to its
factory set default settings. Use a blunt stylus to hold down the
button.

MAINTENANCE

When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact
with water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive materials.
Abrasive cleaning agents may scratch the plastic parts and
corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust,
temperature, or humidity. Such treatment may result in
malfunction, a shorter electronic life span, damaged batteries, or
distorted parts.
4. Do not tamper with the unit's internal components. Doing so
will terminate the unit's warranty and may cause damage. The
unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may leak.
6. Read this instruction manual thoroughly before operating the
unit.

SPECIFICATIONS

Temperature Measurement
Main unit
Operating range
Temperature resolution
Remote unit
Operating range
Temperature resolution
RF Transmission Frequency : 433 MHz
9
: 23.0°F to 122.0°F
(-5.0°C to +50.0°C)
: 0.1°F (0.1°C)
: -20.0°C to +60.0°C
(-4.0°F to 140.0°F)
: 0.1°F (0.1°C)

Advertisement

Table of Contents
loading

Table of Contents