Disabling An Alarm; Enabling An Alarm; How To Stop An Alarm; Snooze - Oregon Scientific WR103 User Manual

5. After selecting the minutes, press MODE or wait
9 seconds to exit Alarm-Setting Mode and return to
Clock-Display mode. The alarm ON icon (
chosen alarm, will be shown to indicate that the
alarm is set and will sound at the set time.
When an alarm goes off, it will sound for 1 minute, the EL
backlight will activate. Alarms 1 and 2 are identified by
different sounds: Alarm 1 has 2 short bursts of sound
followed by a pause which then repeats. Alarm 2 has 4
short bursts of sound followed by a pause, which then
repeats. Unless disabled, the alarms will sound for a total
of 1 minute before automatically turning off.

DISABLING AN ALARM

When disabled, the respective alarm icon will not be
displayed. A disabled alarm display is indicated by blanks
[----].
To disable alarm (1 or 2):
Press MODE to enter alarm-1 or alarm-2 display followed
by or
.
When an alarm is activated, the alarm time will
NOTE
be displayed in the alarm display. In the Clock-Display
mode, the respective alarm-on icon will appear indicating
that alarm1, 2 (or both) is set.

ENABLING AN ALARM

When disabled, the respective alarm icon will not be
) for the
displayed. The display will show blanks [----].
To enable alarm (1 or 2):
Press MODE to enter alarm 1 or alarm 2 display followed
by or
and the [----] alarm time will be replaced with the
alarm time set.

HOW TO STOP AN ALARM

An alarm can be disabled but remain set so that it will
activate at the same time the following day.
To stop an alarm:
When the alarm sound is activating, press any button
(except
and will activate again at the same time the next day.

SNOOZE

W h e n e i t h e r a l a r m 1 o r 2 s o u n d s , p r e s s i n g
before it sounds again.
BACKLIGHT
14
.The respective alarm-on icon will appear
). The alarm will be stopped
will stop the alarm for 8 minutes