Page of 136

Compaq PRESARIO CQ42 Maintenance And Service Manual Page 85

Compaq laptop user manual.
Release the system board by sliding it to the right at an angle (3) until the connectors on the left
side of the system board clear the base enclosure, and then remove the system board.
If it is necessary to replace the modem module cable, remove the RJ-11 connector (1) from the
clip built into the base enclosure.
Remove the modem module cable (2) from the routing channel built into the base enclosure.
The modem module cable is available using spare part number 610791-001.
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
Fan/heat sink assembly (see
Processor (see
Processor on page
Reverse the preceding procedure to install the system board.
Fan/heat sink assembly on page
Component replacement procedures

   Related Manuals for Compaq PRESARIO CQ42

This manual also for:

Presario cq42-300 - notebook pc, G42-400 - notebook pc

Comments to this Manuals

Symbols: 0
Latest comments: