Page of 2
Download Bookmark Comment

Olympus VN-5000 User Manual

Olympus vn-5000: user guide.
Hide thumbs
   
4 Press the + or – button to select the proper
h Inserting Batteries
h Setting Time and Date [TIME]
h To Pause Recording
sound volume.
1 Press down on the arrow and slide the
If you have set the time and date, information as to when a sound file was recorded is stored
To Pause:
• The display shows the volume level. You can choose
Built-in speaker
automatically with that file.
between [00] to [30].
battery cover open.
DIGITAL VOICE RECORDER
While the recorder is during recording mode, press
When you install batteries for the first time or each time you replace the batteries, the
the REC (s) button
VN-5500
"Hour" indication will flash. In such a case, be sure to set the time and date by following
• [PAUSE] appears on the display and the record/play indicator
steps 4 through 7 described below.
light flashes.
VN-5000
1 Press and hold the DISP/MENU button for 1
h Canceling Playback
To Resume Recording:
second or longer.
Press the REC (s) button again.
To Stop:
INSTRUCTIONS
EN
• Recording will resume at the point of interruption.
Press the STOP (4) button.
2 Insert two size-AAA alkaline batteries,
• The recorder stops in the middle of the file being played.
Thank you for purchasing an Olympus Digital Voice Recorder.
observing the correct polarity.
Please read these instructions for information about using the product correctly and safely.
2 Press the + or – button to
h Notes for Recording
Keep the instructions handy for future reference.
select [TIME].
• If [FULL] appears on the display, you cannot record in the selected folder. In such a case, erase
To ensure successful recordings, we recommend that
3 Press the PLAY ( ` ) but-
unnecessary fi les.
To Resume Playback:
you test the record function and volume before use.
• If the recorder is placed directly on a table when recording a meeting, it tends to pick up table
ton.
vibrations. Put a notebook or other item between the table and the recorder so that the vibration
Press the PLAY ( `) button again.
• The "Hour" indicator flashes.
is not easily transmitted for clearer recording.
• Playback will resume at the point of interruption.
• Even if you press the DISP/MENU button, the display will not change to current recording time
if the remaining recording time is 5 minutes or less.
Shinjuku Monolith, 3-1 Nishi-Shinjuku 2-chome, Shinjyuku-ku, Tokyo 163-0914, Japan. Tel. 03-3340-2111
• When remaining recording time is less than 60 seconds, the record/play indicator light starts
4 Press the + or – button to
http://www.olympus.com
fl ashing in red. When the recording time is decreased to 30 or 10 seconds, the light fl ashes
3 Close the battery cover completely.
set the "Hour".
faster.
• The recorder will enter Stop mode if it has been left paused for 60 minutes or longer.
5 Press the PL AY ( ` ) or
• Time and date display appears.
3500 Corporate Parkway, P.O. Box 610, Center Valley, PA 18034-0610, U.S.A. Tel. 1-888-553-4448
• In case of diffi cult acoustic conditions or low speaker's voice, recording in [HQ] is recommended.
h Forwarding and Rewinding
• The "Hour" indicator flashes, indicating the start
9 button to accept the
Also, usage of an external microphone (sold separately) could improve the quality of
http://www.olympusamerica.com
of the time and date setup process. (See "Setting
recordings.
"Minute".
Time and Date [TIME]" for details).
Fast Forward:
• The "Minute" indicator flashes.
• Pressing the 0 button enables
(Premises/Goods delivery) Wendenstrasse 14-18, 20097 Hamburg, Germany. Tel. 040-237730
While the recorder is during playback mode, press and
the "Hour" setting again.
(Letters) Postfach 10 49 08. 20034 Hamburg, Germany.
h Recording from external Microphone or other Devices
hold the 9 button.
http://www.olympus-europa.com
• When you release the 9 button, the recorder will resume
An optional Ni-MH Rechargeable Battery (BR401)
from Olympus can be used for the recorder.
normal playback.
The external microphone and other devices can be connected
Replacing Batteries:
Rewind:
Vision House 19 Colonial Way Watford Herts WD24 4JL. Tel. +44(0) 1923 831000
and the sound can be recorded.
• When using an external microphone, select adequate
http://www.olympus.co.uk
Converting
microphone, such as a Noise-Cancellation microphone or
When [N] appears on the display, replace the batteries as soon aspossible. Size-AAA alkaline
plug adapter
While the recorder is during playback mode, press and
Electret condenser microphone (optional).
batteries are recommended. When the batteries are depleted, [O] appears on the display, and
of KA333
hold the 0 button.
A audio input
• To connect the recorder to an external device, use the
the recorder shuts off. It is recommended to set the HOLD switch to the [HOLD] position before
6 Press the + or – button to
• When you release the 0 button, the recorder will resume
terminal of
connecting cord KA333 (optional), and the stereo/monaural
you replace batteries to maintain the current settings (Time and date, etc.). For your convenience,
other devices
normal playback.
set the "Minute".
converting plug adapter supplied with KA333.
the recorder also logs the current settings in nonvolatile memory at hourly intervals.
Notes:
• Repeat steps 5 and 6 to con-
• The input level cannot be adjusted on this recorder. When
• The end of the fi le is located by pressing and holding the 9 button during fast forwarding.
you connect the recorder to an external device, execute a test
tinue to set the "Year", "Month"
The recorder will pause at the end of the fi le. If you do not release the 9 button, the recorder
recording and adjust the output level of the external device.
and "Date" in the same way.
will continue to fast forward.
• The beginning of the fi le is located by pressing and holding the 0 button during rewinding.
7 After setting the "Date",
h Power Supply
The recorder will pause at the beginning of the fi le. If you do not release the 0 button, the
press the PLAY ( `) or 9
recorder will continue to rewinding.
Introduction
The HOLD switch functions as a power button. When you do not use the recorder, set the HOLD
button.
• When the index mark is shown in the middle of a fi le, it will stop temporarily in the position of the
switch to the [HOLD] position while the recorder is stopped. This will power off the recorder and
• This completes the time and date
index mark.
h LCD Display Information
minimize the battery drain.
setup procedure.
The contents of this document may be changed in the future without advanced
Power on: Reset the HOLD switch.
notice. Contact our Customer Support Center for the latest information relating to
h Locating the Beginning of the File:
You can select an option for the display of the recorder. This will help review and confirm different
Power off: Set the HOLD switch to the [HOLD]
product names and model numbers.
recorder settings and file information.
The utmost care has been taken to ensure the integrity of the contents of this
position.
While the recorder is during playback mode (playback
document. In the unlikely event that a questionable item, error, or omission is
Notes:
or playback in slow/fast mode), press the 9 or 0
Standby Mode and Display Shut Off:
found, please contact our Customer Support Center.
• You can switch the time indication between the 12-hour system and the 24-hour system by
State of the recorder
Operation
Display
button forwards or rewinds to the beginning of the
Any liability for passive damages or damage of any kind occurred due to data loss
pressing the DISP/MENU button while you are setting the hour or minute.
If the recorder is stopped or paused for 60 minutes
next file or the file being played respectively.
incurred by a defect of the product, repair performed by the third party other
• You can change the order of the date indication by pressing the DISP/MENU button while you
While in stop mode
Press and hold the STOP
The total number of files recorded in the
or longer during recording or play back, it goes into
Notes
than Olympus or an Olympus authorized service station, or any other reason is
are setting the year, month, or day.
Standby (power-save) mode, and the display shuts off.
(4) button
folder and remaining recording time appears
Example: July 14, 2008
• If an index mark is encountered midway, playback begins at that
excluded.
on the display.
To exit Standby mode and turn on the display, press
point. (See "Index Marks" for details)
h Safe and Proper Usage
any button.
While in record mode
Press the DISP/MENU
The display switches between current
Before using your new recorder, read this manual carefully to ensure that you know how to operate
button
recording time and remaining recording
it safely and correctly. Keep this manual in an easily accessible location for future reference.
time.
h Changing Playback Speed:
• The warning symbols indicate important safety related information. To protect yourself and others from
h How to Use the
Recording
hHold
personal injury or damage to property, it is essential that you always read the warnings and information
While in stop mode or
Press the DISP/MENU
Playing time ➔ Remaining playing time
provided.
While the recorder is during playback mode, press the
Strap
playback mode
button
➔ Recording date of the file ➔ Recording
Set the HOLD switch to the [HOLD] position. All opera-
PLAY ( `) button.
time of the file ➔ Playing time ...
tion buttons are disabled. This feature is useful when the
Getting Started
Slow Playback
Fast Playback
recorder has to be carried in a handbag or pocket.
1 Press the FOLDER/INDEX
Normal speed
(-25%)
(+50%)
Remember to reset the HOLD switch before attempting
a
to use the recorder.
button to select the desired
b
h Identification of Parts
Playback
Notes:
folder.
• The alarm will sound at the scheduled time even if the
a Current microphone sensitivity
recorder is set to [HOLD] position. The recorder will
Notes:
9
9 EAR (Earphone) jack
b Current folder
1 Built-in Microphone
1
then begin to play the fi le associated with the alarm
• When the slow playback mode is selected, the [J] appears and, for the fast playback mode, [K]
2 MIC (Microphone) jack
0 Display (LCD panel)
once you press any button.
1 Press the FOLDER/INDEX
appears on the display while the recorder is playback.
2
3 HOLD switch
! Record/play indicator
• The recorder functions as follows with the HOLD switch
• The recorder stops playback when you press the STOP (4) button while playback in the slow/fast
Strap hole
a
button to select the de-
4 STOP (4) button
set to the [HOLD] position:
2 Press the REC (s) button
mode, or when it reaches to the end of the fi le. If you once press the STOP (4) button and start
c
light
playback again, the recorder will playback fi les in normal speed as well.
5 PLAY ( `) button
@ REC (s) button
– If the recorder is playing, the display goes dark when
sired folder.
to start recording.
0
playback of the current file has completed.
# + button
a Current folder
6 0 (Rewind) button
d
• The record/play indicator light
– If the recorder is recording, the display goes dark
3
7 Battery cover
$ 9 (Fast Forward)
when the recorder stops recording automatically
• Strap is not supplied.
turns red, and recording starts.
!
h Listening with Earphone
8 FOLDER/INDEX
c Current recording mode
button
upon running out of free memory.
e
@
% – button
d Current file number
4
f
button
2 Press the 9 or 0 button to select the file
#
e Recording level meter
You can listen to files by connecting earphones to the earphone
^ DISP/MENU button
5
$
f Recording time
to playback.
jack. If an earphone is connected, the speaker doesn't emit sound.
& ERASE (s) button
h Notes on the Folders
6
Current folder
%
Sound will be played back monaurally.
3 Press the PLAY ( `) button
7
3 Press the STOP (4) button
^
Notes:
The recorder provides four folders, [F], [G], [H] and [I]. To change the
8
to start playback.
• To avoid irritation to the ear, insert the earphone after you turn
&
folder selection, press the FOLDER/INDEX button while the recorder is
to stop recording.
b
down the volume level.
• The record/play indicator light
stopped. Each recorded file is stored in a folder.
• New recordings are saved as the
• When you listen with the earphone during playback, do not raise
turns green, and the elapsed
Note:
last file in the folder.
the volume too much. It may cause hearing impairment and loss
playing time is indicated on the
g Remaining recording time
• Using folders to classify fi les makes it convenient to fi nd fi les you want
in hearing ability.
display.
c
to access later. Up to a total of 100 fi les can be recorded in each folder.
• Earphones are not supplied. You can use any standard 3.5mm
g
b Current file number
monaural earphone or headphone.
c Playing time
U1-BS0120-01
AP0807
-
1
-
-
2
-
-
3
-
-
4
-
-
5
-

   Related Manuals for Olympus VN-5000

   Summary of Contents for Olympus VN-5000

  • Page 1

    Any liability for passive damages or damage of any kind occurred due to data loss incurred by a defect of the product, repair performed by the third party other than Olympus or an Olympus authorized service station, or any other reason is excluded.

  • Page 2

    63 g (including battery) 120 mW • Battery life is measured by Olympus. It varies greatly according to the type of batteries used and the conditions of use. • Your recorded contents are for your personal use or pleasure only. It is prohibited to record copyrighted material without permission of the copyright holders according to copyright law.

This manual also for:

141985 - vn 5000 512 mb digital voice recorder

Comments to this Manuals

Symbols: 0
Latest comments: