Usb Drive Requirements; Readyshare Access; Safely Remove A Usb Drive - NETGEAR WNDR3800 - N600 WIRELESS DUAL BAND GIGABIT ROUTER-Premium Edition User Manual

N600 Wireless Dual Band Gigabit Router Premium Edition WNDR3800

USB Drive Requirements

The router works with 1.0 and 1.1 (USB Full Speed) and 2.0 (USB High Speed) standards.
The approximate USB bus speeds are shown in the following table. Actual bus speeds can
vary, depending on the CPU speed, memory, speed of the network, and other variables.
Table 3. USB Drive Speeds
Bus
USB 1.1
USB 2.0
The router should work with most USB-compliant external flash and hard drives. For the most
up-to-date list of USB drives supported by the router, go to:
http://kbserver.netgear.com/readyshare
The router supports both read and write for FAT16, FAT32, NTFS, and Linux file systems
(EXT2 and EXT3).
Some USB external hard drives and flash drives require drivers to
Note:
be loaded in to the PC before the PC can access the USB device.
Such USB devices will not work with the router.

ReadySHARE Access

Once you have set up your router, you can connect any USB storage device and share the
contents with other users on your network.
You can access your USB device in any of the following ways:
On Windows 7, Windows XP, Windows Vista, and Windows 2000 systems, select Start >
•
Run and enter \\readyshare in the dialog box. Click OK.
On Windows 7, Windows XP, Windows Vista, and Windows 2000 systems, open Internet
•
Explorer, and enter \\readyshare in the address bar.
On Mac OS X (version 10.2 or later), enter smb://readyshare in the address bar.
•
In My Network Places, enter \\readyshare in the address bar.
•

Safely Remove a USB Drive

To safely remove a USB disk drive so that no users can access it, select USB Storage >
Basic Settings and click the Safely Remove USB Device button. This takes the drive
offline.
Speed/Sec
12 Mbits
480 Mbits
USB Storage
48