Network Without A Dhcp Server - NETGEAR ProSafe GS108 User Manual

GS108T Smart Switch Software Administration Manual
.
Figure 1-2
Use your web browser to manage your switch. The default password is 'password'. Then use this
page to proceed to management of the switch covered in
Browser Interface".

Network without a DHCP Server

This section describes how to set up your switch in a network without a DHCP server, and is
divided into the following tasks:
• Manually assign network parameters for your switch
• Configure the NIC settings on the host PC
• Log in to the web-based switch management utility
1-4
Chapter 2, "Introduction to the Web
Getting Started with Switch Management
v1.0, May 2007