Removing The Base - NEC AccuSync LCD52VM User Manual

Quick Start

Removing the Base

Note: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive
surface.
2. While using your thumbs, press the tabs in the
direction of the arrows to unlock the stand.
3. Pull the unlocked base off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
Specifications
4-SCREWS (M4)
(MAX depth: 8.5 mm)
If using other screws,
check depth of holes.
–continued
Replace screws
75 mm (LCD52VM)
100 mm (LCD72VM)
100 mm (LCD92VM)
6
75 mm (LCD52VM)
100 mm (LCD72VM)
100 mm (LCD92VM)
Weight of LCD assembly:
2.9 kg - LCD52VM (MAX)
4.3 kg - LCD72VM (MAX)
5.5 kg - LCD92VM (MAX)
Thickness of
Bracket (Arm)
2.0~3.2 mm
Tighten all
screws.