McCall 1-1020HP Specifications

1-1020HP
McCall Refrigeration specification sheets are available
online @ www.mccallrefrigeration.com
Cabinet - Cabinets are all metal, inside and out. The top,
and bottom are made of galvanized steel. In addition, all
seams are closed and sealed, with metal edges turned
away from the exposed surface. The result is an
integrated structural frame. Internal corners are coved to
conform to NSF standards. Automatic interior lighting is
controlled by a light switch concealed in the door hinge.
The cabinet is supported on four 6 inch adjustable legs.
Doors - Constructed of metal, heated cabinet doors are
self-closing and fully insulated. Their cam-lift hinges are
chrome-plated and self-lubricating. Hinges also have a
safety stop that holds the door open at 95°, preventing
overswing. Chrome-plated pull handles have built-in
cylinder locks. The full-perimeter, magnetic vinyl gaskets
are removable without the use of tools. Doors easily lift
Phone (731) 847-5570 / Fax (731) 847-9012 / 1-888-REACH-IN (1-888-732-2446) / www.mccallrefrigeration.com
P
H
( 1 & 2 S
Model 1-1020HP & 1-1045HP
Stainless steel cabinet interior and exterior front, sides and doors.
Model 2-2020HP & 2-2045HP
Stainless steel cabinet exterior front, sides and doors.
Heavy gauge aluminum cabinet interior with stainless steel floors.
Model 4-4020HP & 4-4045HP
Heavy gauge anodized aluminum cabinet exterior sides.
Stainless steel Front and doors cabinet exterior.
Polished aluminum cabinet interior with stainless steel floors.
Models are available with full doors, as shown, or with
half doors.

Standard Features

• Cord and plug attached (115V only, less than 16 amps)
• Master power switch
• Unique air distribution system provides an even heat at lower
wattages
• Self-closing cam-lift hinges
• Stainless steel breaker around full door perimeter
4-4045HP
• Chrome-plated door handles with security locks
• 6 inch adjustable legs
• Baked epoxy-coated shelves adjustable on 1 inch centers
• Adjustable doorstops at 90˚ and 180˚
SPECIFICATIONS
off, and door openings are protected by stainless steel
breaker strips.
Insulation - Cabinet body, doors, and evaporator coil
housings are filled with pressure-injected polyurethane
foam. Cabinet body, doors, and heated element housings
are filled with pressure injected and expanded closed-
cell polyurethane foam.
Interior Shelves - Three wire shelves are standard.
Shelves have a runner spaced 3/4 inch O.C. with two
reinforcing bars 8 1/2 inch O.C. Coated with 7 mils of
baked-on gray epoxy. The shelves have
a saline spray corrosion resistance of 600 hours.
Shelves will support 250 pounds each with maximum
cabinet load of 800 lbs. They are supported on stainless
McCall Refrigeration / 81 West Holly Street / Parsons, TN 38363
January 2007 / Printed in U.S.A.
ITEM #
MODEL #
PROJECT NAME
-T
ASS HRU
H
EATED OLDING
ECTION
Approval :
steel pilasters, and are adjustable on 1 inch centers. All
three shelves are interchangeable and can be adjusted
without tools or special parts.
Heating System - Components include a fin strip
heating element, thermostat, circulating fans, on/off
switch, and a pilot light. The entire system is sized
and balanced to maintain temperatures between 140
degrees F and 170 degrees. The convected air
distribution system maintains an even temperature
throughout the cabinet. All components are factory
installed and tested, and supplied with master power
switch and exterior digital thermometer (1000 series)
dial thermometer (2000-4000 series). Cord and plug
provided on 115 volt models, less than 16 amps.
AIA #
SIS #
C
ABINETS
)