McCall 1-1045P Specifications

4-4045PGD
McCall Refrigeration specification sheets are available online
@ www.mccallrefrigeration.com
Cabinet - Cabinets are all metal, inside and out.
The top and bottom are made of galvanized steel.
In addition, all seams are closed and sealed, with
metal edges turned away from the exposed
surface. The result is an integrated structural
frame. Internal corners are coved to conform to
NSF standards. Automatic interior lighting is
controlled by a light switch concealed in the door
hinge, except glass door models employ a
manual switch.
Doors - Constructed of metal, refrigerator doors
are self-closing and fully insulated. Their cam-lift
hinges are chrome-plated and self-lubricating.
Hinges also have a safety stop that holds the door
open, preventing overswing. Chrome-plated pull
handles have built-in cylinder locks. The full-
perimeter, magnetic vinyl gaskets are removable
without the use of tools. Doors easily lift off, and
door perimeters have a built-in, low wattage, and
anti-condensate heater. Door openings are
protected by an impact-resistant, nonconductive
Phone (731) 847-5570 / Fax (731) 847-9012 / 1-888-REACH-IN (1-888-732-2446) / www.mccallrefrigeration.com
P -T
ASS HRU
CLASSIFIED TO
NSF (STD-7-1999)
SPECIFICATIONS
PVC breaker strip with no exposed screws
or fasteners.
Insulation - Cabinet body, doors, and evaporator
coil housings are filled with pressure-injected
polyurethane foam.
Interior Shelves - Three wire shelves per section
are standard. Shelves have a runner spaced 3/4
inch O.C. with two reinforcing bars 8 1/2 inch O.C.
Coated with 7 mils of baked-on gray epoxy. The
shelves have a saline spray corrosion resistance of
600 hours. Shelves will support 250 pounds each
with maximum cabinet load of 800 lbs. They are
supported on stainless steel pilasters (1000 series)
& aluminum pilasters (2000-4000 series), and are
adjustable on 1 inch centers. All three shelves are
interchangeable and can be adjusted without tools
or special parts.
Self-Contained Refrigeration - The complete
refrigeration assembly is mounted on top of the
McCall Refrigeration / 81 West Holly Street / Parsons, TN 38363
January 2007 / Printed in U.S.A.
ITEM #
MODEL #
PROJECT NAME
R
EFRIGERATORS
Model 1-1045P
Stainless steel cabinet interior and exterior
front, sides, and doors.
Model 2-2045P
Stainless steel cabinet exterior front, sides, floor and doors.
Heavy guage aluminum cabinet interior with
stainless steel floors
Model 4-4045P
Heavy gauge anodized aluminum cabinet exterior sides.
Stainless steel cabinet fronts and doors ecept for aluminum
ends that wrap around front.
Heavy guage aluminum cabinet interior with stainless steel floors.

Standard Features

• Top mounted compressor and evaporator coil
• Expansion valve
• Hot gas condensate evaporator
• R-134a refrigerant
• Cord and plug attached (self-contained only)
• Windrunner gradient air displacement process
• Exterior digital thermometer (1000 series) dial thermometer (2000-4000 series)
• Self-closing cam-lift hinges
• Chrome-plated door handles with security locks
• 6 inch adjustable legs
• Baked epoxy-coated shelves adjustable on 1 inch centers
• Concealed light switch
• Stainless steel pilasters (1000 series) & aluminum pilasters (2000-4000 series)
• Automatic defrost
• Adjustable doorstops
Approval :
SIS #
(2
SECTION
cabinet behind a removable hatch cover.
Refrigeration components include a hermetically
sealed compressor, thermostatic expansion valve,
thermostatic temperature control, high-humidity
coated evaporator coil and hot gas condensate
evaporator. The systemis balanced to maintain
38°F average internal air temperature. Windrunner
gradient air displacement process provides even
air flow and temperature control throughout the
cabinet. All components are factory installed and
tested, and supplied with an attached cord and
plug (self-contained, 115 volt only less than 16
amps), master power switch, and exterior
digital thermometer (1000 series) dial thermometer
(2000-4000 series).
Remote Cabinets - Standard remote units are
provided with capped refrigeration lines, expansion
valve, solenoid valve, electric condensate
evaporator, and temperature control. Condensing
unit is not included. All other features are the
same as self-contained units, except power cord.
AIA #
)