Coby CX-CD250 Instruction Manual

COBY
MODEL NO: CX-CD250
PORTABLE CD/RADIO/STEREO CASSETTE PLAYER/RECORDER
with REMOTE CONTROL
Please read instruction manual before use.

LOCATION OF CONTROLS

1.Function Selector
8.Tuning Indicator Window
2.Volume Control 9.CD Compartment Open/Close Button
10.Tuning Control
3.Cassette Operation Buttons
4.Cassette Compartment 11.Band Selector
5.CD Display 12.CD Compartment
13.Telescopic Antenna
6.Remote Sensor
7.CD Operation Buttons
10
13 12 11
1
2
3

REMOTE CONTROL

PLAY button STOP button
REW button F.FWD button
RANDOM button
PROG button
G O R P
M O D N A R REPEAT button
T A E P E R
L L A / E N O
IMPORTANT SAFEGUARDS
Always operate the product from a power supply
of the same voltage, frequency and rating as indicated
on the product identification plate.
Do not operate product with a damaged cord or plug.
Never install the unit where there are heat sources such
as radiators, heat registers, stoves, direct sunlight,
excessive dust or where there is mechanical vibration
or shock. Switch off and unplug from AC outlet when not
in use.
IMPORTANT
9
The CD mechanism and the sensitive circuitry may
cause interference to a radio tuner nearby. Do not
8
operate this unit while operating other radio devices.
Danger This product utilizes invisible laser
7
radiation. Avoid direct exposure
to the beam.
6
5
Caution Use of controls, adjustments or procedures
not listed in this manual may result in hazardous
4
radiation exposure.
CONCERNING COMPACT DISCS
Only compact discs identified with this
mark can be used with this player.
CARE and MAINTENANCE
Handle your unit with care to extend the life of the unit.
Use a soft and clean cloth damped with plain lukewarm water
to clean the exterior of the unit.
Never use solvents such as benzene or other strong chemical
cleaners since these could damage your unit.
It is important that no liquid reaches the inside of the unit.
Do not touch the CD laser part or look directly at it.
INTRODUCTION
Please read and follow the instruction manual carefully be-
fore operating in order to avoid any damage to the unit.
POWER SUPPLY
1.By using AC power
Insert one end of the AC power cord into the AC socket
on the rear of the unit and the other end into a standard
wall socket.
.
2 By using batteries
Insert 8x"D"size batteries (not included) in the battery
compartment in the back of the unit by matching the
polarities.
The unit will not operate on battery power when
the AC power cord is plugged into the AC socket.
Replace batteries when the power indicator dims,
the volume decreases or the sound distorts.
Use batteries of high quality and check them
regularly. Alkaline batteries are recommended.
Do not mix new batteries with old or used batteries.
Use only batteries of the same brand and type
Batteries should not be left in the unit if they
are exhausted or if the unit is not to be used
for a long period of time as they may leak and
damage the unit. Battery leakage is not covered
under the warranty.