Fan Power Connectors: Cpufan1/Sysfan1; Ide Connectors: Ide1 & Ide2 - MSI 848P Neo-V Series Instruction Manual

CD-In Connector: CD1
The connector is for CD-ROM audio connector.
S-Bracket Connector: JSP1 (Optional)
The connector allows you to connect a S-Bracket for Sony & Philips Digital Interface
(SPDIF). The S-Bracket offers 2 SPDIF jacks for digital audio transmission (one for
optical fiber connection and the other for coaxial), and 2 analog Line-Out jacks for 4-channel audio output.
To attach the fiber-optic cable to optical SPDIF jack, you need to remove the plug from the jack first. The
two SPDIF jacks support SPDIF output only.

Fan Power Connectors: CPUFAN1/SYSFAN1

The CFAN1 (processor fan) and SFAN1 (system fan) support system cooling fan
with +12V. They support three-pin head connector. When connecting the wire to the connectors, always
take note that the red wire is the positive and should be connected to the +12V, the black wire is Ground
and should be connected to GND. If the mainboard has a System Hardware Monitor chipset on-board, you
must use a specially designed fan with speed sensor to take advantage of the CPU fan control.
MSI Reminds You...
1. Always consult the vendors for proper CPU cooling fan.
2. CPUFAN1 supports the fan control. You can install the PC Alert utility that will automatically control the
CPU fan speed according to the actual CPU temperature.
IDE Connectors: IDE1 & IDE2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100 controller that provides PIO mode
0~5, Bus Master, and Ultra DMA 33/66/100 function. You can connect up to four hard disk drives, CD-ROM,
120MB Floppy and other devices. These connectors support the provided IDE hard disk cable.
IDE1 (Primary IDE Connector):
The first hard drive should always be connected to IDE1. IDE1 can connect a Master and a Slave drive. You
must configure second hard drive to Slave mode by setting the jumper accordingly.
IDE2 (Secondary IDE Connector): IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its
jumper. Refer to the hard disk document supplied by hard disk vendors for jumper setting instructions.
G ND
R
L
8
SO UT -R
SOUT -L
SPD FO
VD D3
GND
12
2
11
1
VC C5
GND
SPDF O
CET-OU T
GND
LF E -OUT
+12V
GND SENSOR