Power Supply; Floppy Disk Drive Connector: Fdd1 - MSI 848P Neo-V Series Instruction Manual

Memory
The mainboard provides 2/3 slots for 184-pin, 2.5V DDR DIMM modules and supports the memory size up
to 2 GB/3GB without ECC. You can install DDR266/DDR333/DDR400 DDR SDRAM modules on the DDR
DIMM slots. To operate properly, at least one DIMM module must be installed.
(For the updated supporting memory modules, please visit
http://www.msi.com.tw/program/products/mainboard/mbd/pro_mbd_trp_list.php.)
1. The DDR DIMM has only
one notch on the center of
module. The module will only fit in
the right orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the golden finger
on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.

Power Supply

The mainboard supports ATX power supply for the power system. Before inserting the power supply
connector, always make sure all components installed properly and ensure no damage to be caused.
ATX 20-Pin Power Connector: ATX1
This connector allows you to connect to an ATX power supply. To
connect to the ATX power supply, make sure the plug of the power
supply is inserted in the proper orientation and the pins are aligned.
Then push down the power supply firmly into the connector.
ATX 12V Power Connector: JPW1
This 12V power connector is used to provide power to the CPU.

Floppy Disk Drive Connector: FDD1

The mainboard provides a standard floppy disk drive connector that
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
Volt Notc h
20
10
GN D
7
5V GND
GND
PS_ ON
5V - 5V GN D
5V _ SB GND
GND
12 V
PW_OK 5V
3 4
12 V
12 V
GN D
1 2
3. 3V
GND
-12 V
11
1
GND 3. 3V
5V 3. 3V