Installing Ddr Modules; Power Supply - MSI 651M-V Instruction Manual

Install at least one DIMM module on the slots. Memory modules can be installed on the slots in any
order. You can install either single- or double-sided modules to meet your own needs.

Installing DDR Modules

1. The DDR DIMM has only one notch on the center of module. The module will only fit in the right
orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the golden
finger on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
MSI Reminds You...
Overheating...
Overheating will seriously damage the CPU and system, always make sure the cooling fan can work
properly to protect the CPU from overheating.
Replacing the CPU...
While replacing the CPU, always turn off the ATX power supply or unplug the power supply's power
cord from grounded outlet first to ensure the safety of CPU.

Power Supply

The mainboard supports ATX power supply for the power system. Before inserting the power supply
connector, always make sure that all components are installed properly to ensure that no damage will
be caused.
ATX 20-Pin Power Connector: CONN1
This connector allows you to connect to an ATX power supply. To
connect to the ATX power supply, make sure the plug of the power supply
is inserted in the proper orientation and the pins are aligned. Then push
Volt N ot ch
6
5V GND
GND GND
PS_ ON
5V -5V GN D
20
10
5V _ SB GND
GND GND
12 V
PW_OK 5V 5V
3. 3V
-12 V
11
1
3. 3V
3. 3V