Set Supervisor/User Password - MSI 651M-V User Manual

Set Supervisor/User Password

When you select this function, a message as below will appear on the screen:
Type the password, up to eight characters in length, and press <Enter>. The
password typed now will replace any previously set password from CMOS memory.
You will be prompted to confirm the password. Retype the password and press
<Enter>. You may also press <Esc> to abort the selection and not enter a password.
To clear a set password, just press <Enter> when you are prompted to enter
the password. A message will show up confirming the password will be disabled.
Once the password is disabled, the system will boot and you can enter Setup
without entering any password.
When a password has been set, you will be prompted to enter it every time
you try to enter Setup. This prevents an unauthorized person from changing any part
of your system configuration.
Additionally, when a password is enabled, you can also have BIOS to re-
quest a password each time the system is booted. This would prevent unauthorized
use of your computer. The setting to determine when the password prompt is re-
quired is the Security Option of the Advanced BIOS Feature menu. If the Secu-
rity Option is set to [System], the password is required both at boot and at entry to
Setup. If set to [Setup], password prompt only occurs when you try to enter Setup.
MSI Reminds You...
About Supervisor Password & User Password:
Supervisor password: Can enter and change the settings of the
User password:
setup menu.
Can only enter but do not have the right to
change the settings of the setup menu.
BIOS Setup
3-23