Download Print this page

Magnet Mount - Lowrance LGC-2000 Installation Instructions Manual

Gps module

Advertisement

vehicle supply stores will help hold the antenna in place. This may not
work well if you have a cab-over design pickup truck camper or motor
home. If dashboard reception is poor, simply relocate the antenna mod-
ule elsewhere on the vehicle for a clearer view of the sky.
LGC-2000 Module, bottom view (left) and top view (right).
Once you've determined the mounting location, use the template on
page 3 to drill the screw holes. The screws supplied with this unit are
about 1-1/8" long (4mm x 30mm). Drill 3/16" (4.75 mm) holes for the
mounting screws.
If you need to route the cable through the mounting surface, drill a 1"
(25mm) hole for the cable's connector. There is a notch in the antenna
housing that allows the cable to pass through to the outside, if desired,
instead of routing it through the mounting surface.
After drilling the holes, pass the O-ring over the cable and press it into
the groove on the bottom of the antenna housing. Now attach the an-
tenna to the mounting surface, using 4mm screws and the supplied lock
washers. Route the cable and the GPS module installation is finished.

Magnet Mount

A magnet (available as an option) lets you temporarily mount the GPS
module on any ferrous metal surface, such as a car. To use the magnet,
simply peel the backing off the magnet's adhesive coating and press the
magnet to the bottom of the antenna housing. The module is ready for use.
Magnet
Under side view showing magnet.
2

Hide quick links:

Advertisement

loading