Chapter 6: Advanced Configuration; Setup - Linksys WET200 User Manual

Chapter 
Chapter :
Advanced Configuration
Open your web browser, enter http://9.8.. in
the Address field, and press the Enter key.
Address Bar
NOTE: The default IP address is 9.8...
If the IP address is changed using DHCP, enter
the assigned IP address instead of the default.
The web-based utiity's login screen appears. The first time
you open the utility, enter admin (the default username)
in the username field, enter admin in the password field,
then click OK. You can change the username and password
later from the Administration tab's Password screen.
Login Screen
After you log in, the Setup screen appears. To access other
screens, select one of the five tabs at the top of the screen:
Setup, Wireless, Switch, Administration, and System
Status. Each tab contains additional screens. These tabs
and their screens are explained in detail below.

Setup

The Setup tab contains one screen, the Setup screen. The
Setup screen contains basic information for the Bridge.
Host Name This is the host name assigned to the Bridge.
This host name will be published to your DNS server if
the Bridge is configured to acquire its IP address through
DHCP. In that case, Linksys recommends following
company policy for host name assignment. The default
name is Linksys.
Device Name You may assign any device name to the
Bridge. This name is used only by the Bridge administrator
for identification purposes. Unique, memorable names
are helpful. The default name is WET00.
Wireless-G Business Ethernet Bridge
Advanced Configuration
Contact
Enter the name of the administrator responsible
for the system.
Location
This field is used for entering a description of
where the Bridge is located, such as 3rd floor.
IP Address Type Select how the WET200 will obtain its IP
address, either Static IP Address (default) or Automatic
Configuration-DHCP.
Automatic Configuration-DHCP
•
obtain its IP address automatically from a DHCP server.
NOTE:
If the DHCP server is not connected to
the Bridge ports but will be accessed via the
wireless interface, you must first create a wireless
connection before attempting to enable DHCP
on the WET200. Otherwise, the device will not
be able to obtain an IP address and the web-
based utility will be inaccessible. For detailed
information on creating a wireless connection,
see the "Wireless > Basic settings" section.
Static IP Address To assign a static IP address to
•
the Bridge, select this option and fill in the IP Settings
fields. You should make sure that this IP address does
not conflict with the IP addresses of any other devices
on the network.
IP Settings If you set the IP Address Type field to Static IP
Address, complete the following fields.
Local IP Address Enter the IP address of the Bridge
•
(default 9.8..) into this field.
Subnet Mask
Enter the subnet mask into this field.
•
Default Gateway
IP address of the gateway router
•
(default 0.0.0.0) on the current IP subnet, used to
reach other IP networks.
Primary DNS Server Enter the IP address of the DNS
•
server (default 0.0.0.0) into the field.
Secondary DNS Server
•
(default 0.0.0.0) can be specified in this field.
Setup Screen
The WET200 will
A second DNS address
9