Hibernation Mode - Lenovo ThinkPad R60 9456 Hardware Maintenance Manual

Lenovo thinkpad r60 9456: hardware guide
Table of Contents

Advertisement

Related service information
To cause the computer to return from standby mode and resume operation, do one
of the following:
v Press the Fn key.
v Open the LCD cover.
v Turn on the power switch.
Also, in either of the following events, the computer automatically returns from
standby mode and resumes operation:
v The ring indicator (RI) is signaled by a serial device or a PC Card device.
v The time set on the resume timer elapses.

Hibernation mode

In hibernation mode, the following occurs:
v The system status, RAM, VRAM, and setup data are stored on the hard disk.
v The system is powered off.
Note: If the computer enters the hibernation mode while it is docked to the
To cause the computer to enter hibernation mode, do any of the following:
v Press the Fn+F12 keys.
v If you are using the APM operating system and have set the mode to Power
v If you are using the ACPI operating system and have defined one of the
Also, the computer goes into hibernation mode automatically in either of the
following conditions:
v If a "hibernation time" has been set on the timer, and if the user does not do
v If the timer conditions are satisfied in suspend mode.
v If you are using the APM operating system and have set the mode to Hibernate
When the power is turned on, the computer returns from hibernation mode and
resumes operation. The hibernation file in the boot record on the hard disk drive is
read, and system status is restored from the hard disk drive.
26
®
MT ThinkPad
ThinkPad R60, R60e, R61, and R61i
Note: The computer does not accept any input immediately after it enters
standby mode. Wait a few seconds before taking any action to reenter
operation mode.
ThinkPad Advanced Dock or ThinkPad Advanced Mini Dock, do not
undock it before resuming normal operation. If you do undock it and then
try to resume normal operation, you will get an error message, and you will
have to restart the system.
switch mode [Hibernation], turn off the power switch.
following actions as the event that causes the system to go into hibernation
mode, perform that action.
– Closing the lid.
– Pressing the power button.
– Pressing Fn+F4 keys.
any operation with the keyboard, the TrackPoint, the hard disk drive, the
parallel connector, or the diskette drive within that time.
when battery becomes low, and the battery charge becomes critically low.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents