La Crosse Technology TX23U Instruction Manual

Wind sensor

Download this manual

WS-2310-15 Wind Sensor

The WS-2310-15 wind sensor is used in conjunction with the WS-2310-16 rain sensor and WS-

2310-25 temperature/ humidity sensor to gather and transmit information to the WS-2300 series

wireless weather station. The WS-2310-15 wind sensor measures the wind speed and direction

and sends the information to the WS-2310-25 temperature/ humidity sensor. This sensor then

transmits all outdoor weather information from the three outdoor sensors to the display indoors.

INVENTORY OF CONTENTS

1. WS-2310-15 wind sensor

2. Mounting bracket

3. Mounting hardware

4. Instruction manual and warranty card

SETTING UP

First, choose to use the adaptor (included in this set) or batteries for operation. Both these

methods allow for operation using wireless 433MHz transmission or cable connection between

the base station and the sensors and setting up for both methods is as follows:

Base Station:

Battery compartment

Socket for

Adaptor

Socket for

Thermo-Hygro

Sensor

PC COM

Port

Page 1 WS-2310-15 Wind Sensor The WS-2310-15 wind sensor is used in conjunction with the WS-2310-16 rain sensor and WS- 2310-25 temperature/ humidity sensor to gather and transmit information to the WS-2300 series wireless weather station. The WS-2310-15 wind sensor measures the wind speed and direction and sends the information to the WS-2310-25 temperature/ humidity sensor.
Page 2 Setting up using batteries: Thermo-Hygro Sensor Sensor sockets Battery Compartment Important: To avoid operating problems, please take note of battery polarity if inserting any batteries. Also do not press any buttons after start up until all sensor information has been displayed and the radio controlled time has set. Doing so may interrupt communication between the sensors and display or interrupt the WWVB time reception.
Page 3 Mounting the wind sensor onto a mast Wind-vane Wind-fan First, check that the wind-fan and the wind-vane can rotate freely before mounting the unit. For correct and accurate readings it is important to mount the sensor so that the front (marked E) is pointing in East-West direction.
Page 4 LIABILITY DISCLAIMER 1. The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any consequences occurring should an inaccurate reading take place. 2. This product is not to be used for medical purposes or for public information. 3.

Ws-2310-15