La Crosse Technology WT-3126B Quick Setup Instructions

Welcome to the world of radio controlled timekeeping technology. We hope you will enjoy the
convenience of never having to set your clock again and the confidence of knowing exactly what time it
is.
• Insert 1 fresh AA, LR6 1.5 volt ALKALINE battery
• Press button to select a time zone. THAT'S IT! During the night your clock will
automatically set itself.
For a better understanding of how and why your clock works please continue reading.
Nothing is more precisely measured than time!
And nothing keeps track of time more precisely and trouble free than La Crosse Technology radio controlled
clocks.
Since the beginning of time, man has been fascinated with the measurement of time and has devised more
accurate machines to trap and measure time. Today, time is precisely measured in the United States by the most
accurate clock in North America, the Atomic Clock of the US National Institute of Standards and Technology,
Time and Frequency Division in Boulder, Colorado. A team of atomic physicists continually measures every
second of every day to an accuracy of ten billionths of a second per day. These physicists have created an
international standard, measuring a second as 9,192,631,770 vibrations of a Cesium 133 atom in a vacuum. This
atomic clock regulates the WWVB radio transmitter located in Fort Collins, Colorado, where the exact time signal
is continuously broadcast throughout the United States at 60 kHz to take advantage of stable long wave radio
paths found in that frequency range. Radio waves at these low frequencies use the earth and the ionosphere as a
wave-guide and follow the curvature of the earth for long distances.
The built in antenna system will receive the WWVB signal anywhere in North America within 2000 miles of
Fort Collins where long-wave radio reception is undisturbed. A microprocessor activates the receiver and
processes the time signal from Fort Collins overnight.
Through the radio signals, La Crosse Technology radio controlled clocks always keep precise time. The
changeover from standard time to daylight savings time, and vice versa, takes place automatically with the same
precision.
Additional details
To set up your clock simply install one fresh AA, LR6 ALKALINE battery. Due to the nature of long wave radio
signals it is normally not possible to receive a signal during the day so it is best to install the battery late in the
evening. Select your time zone by pressing one of the four time zone buttons PT-Pacific Time, MT-Mountain
Time, CT-Central Time, ET-Eastern Time. The time zone buttons may be pressed any time after installing the
batteries. If multiple buttons are pressed the clock will set to the time zone selected last. If no time zone is
selected the clock will default to Pacific Time. Another time zone can be selected during or after the clock has set
itself. Your clock can only set itself to one of the four time zones stated above. For time zones outside of PT,
MT, CT or ET you must manually set the time using the Manual Time set button on the back of the movement.
When the battery is installed the second hand will advance eight seconds (two seconds per step x four
steps). The clock is now searching for a signal. For the initial setting it is recommended to stand the clock in an
upright position near a window. Within five minutes the clock will either receive the WWVB signal and set itself to
the exact time, or it will determine that the signal is not receivable at its current location and time of day. If a
signal is not receivable it will fast-forward the hands to the 4, 8, or 12 o'clock position and search for WWVB each
Radio Controlled Analog Clock
Quick set up instructions