Selecting Output Destination - Kyocera KM-8030 Advanced Operation Manual

2
Press [ ] or [ ] to select Auto Clear
Time Setting and press [Change #].
3 Use [+] to increase or [-] to decrease the
auto clear timeout from 10 to 270
seconds.
4
Press [Close]. The touch panel will return to the Machine Default screen.

Selecting Output Destination

You can specify the default destination for finished copies.
Destination
Auto
Tray A
Tray B
Tray 1
Tray 2
Tray 3
Tray 4
Tray 5
NOTE: This menu is available when the copier is equipped with the optional document finisher.
1 Access the Machine Default screen. (For instructions, refer to Accessing the Machine Default
Screen on page 3-20.)
2
Press [ ] or [ ] to select Select Copy
output mode and press [Change #].
System Menu / Counter
Machine Default
Default menu
Special paper action mode
Orig. Set Direction
Sleep mode changing time
Low power mode chng. time
Auto Clear Time Setting
System Menu
Auto Clear Time Setting
Possible to set time to automatically return to
default status after Copy is done or last operation
System Menu - Machine Default
Description
Copies are sent to the empty tray. If multiple trays are empty,
copies are sent to the bottom tray first and higher trays thereafter.
Tray A of the document finisher.
Tray B of the document finisher. This tray is not available if the
multi-job tray is installed.
Tray 1 (the first tray) of the multi-job tray.
Tray 2 (the second tray) of the multi-job tray.
Tray 3 (the third tray) of the multi-job tray.
Tray 4 (the fourth tray) of the multi-job tray.
Tray 5 (the fifth tray) of the multi-job tray.
System Menu / Counter
Machine Default
Default menu
Orig. Set Direction
Sleep mode changing time
Low power mode chng. time
Auto Clear Time Setting
Select Copy output mode
System Menu
System Settings
Setting mode
Adjust print direction
Rear
90 Minute
Minute
15 15
90 Seconds
90
Seconds
Setting mode
Rear
90 Minute
15 Minute
90 Seconds
Tray A
Change #
Back
Change #
3-29