Selecting Maximum Number Of Copies; Enabling Repeat Copy - Kyocera KM-8030 Advanced Operation Manual

System Settings
3
Press [+] and [-] to specify the widths to
erase the borders.
The range for the width is as follows.
Setting Range
Inch models
Metric models
4
Press [Close]. The touch panel will return to the Copy Default screen.

Selecting Maximum Number of Copies

You can limit the maximum number of copies from 1 to 9999.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2 Press [ ] or [ ] to select Preset limit
and press [Change #].
3 Use the numeric keys to enter the
maximum number of copies from 1 to
9999.
4 Press [Close]. The touch panel will return to the Copy Default screen.

Enabling Repeat Copy

Repeat copy allows to print the original document which was copied and stored in the copier. You
can enable or disable repeat copy and set it as the default.
NOTE: This menu not available when the copier is equipped with the optional security kit.
1
Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
3-16
Default erase width
Adjust default setting of erase width.
System Menu
0 to 2" (in 1/8" increments)
0 to 50 mm (in 1-mm increments)
System Menu / Counter
Copy Default
Default menu
Sort/Offset
Auto Rotation
Default margin width
Default erase width
Preset limit
System Menu
Preset limit
Set output quantity.
System Menu
(0 2) (0
¼
"
Border Center
- Copy Default
Setting mode
Sort:On/Offset:Off
Rotate
¼ "
Left 0 "
Border ¼ " Center
Set
Set
- Copy Default
Back
2)
½
"
½ "
Change #
Back