Important Safety Instructions When using your CL1 signaler, always follow basic safety pre- cautions to reduce the risk of fire, electrical shock and injury to persons, or property, including the following: 1.Read and understand all instructions, warnings and product markings.
2.Plug one side of the phone cord (included) into the LINE IN jack on the back of the CL1 and the other side into your wall jack. 3.Plug your telephone into the LINE OUT jack on the back of the CL1.
Operation 1. Set the Alarm Mode. No Alarm Both Strobe Flasher & Sound Alarm Both Strobe Flasher & Shaker Both Sound Alarm & Shaker 2. Adjust your Volume Control This increases or decreases the volume of the Sound Alarm. 3. Adjust your Tone Control This shapes the sound by increasing the frequencies of the Sound Alarm.
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company. A plug and jack used to connect this CL1 to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA.
Page 7
If trouble is experienced with this telephone equipment, for repair or warranty information, please contact ClearSounds Communication at 1-800-965-9043. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equip- ment until the problem is resolved.
The product must not be tampered with or taken apart by anyone who is not an authorized ClearSounds Communications represen- tative. Tampering with the CL1 will void any written or implied warranties. ClearSounds Communications shall not be responsible for loss...